Pepperl+Fuchs ecom Ex-Handy 10 Quick Start Manual

Battery

The battery of the feature phone is not fully charged.
It is recommended to charge the phone for five hours before
using it for the first time. The full capacity of the battery is
reached after 3-4 complete charge/discharge cycles.

Warranty

The warranty of this product follows the General Conditions
of Delivery and Payment of Pepperl+Fuchs GmbH, which are
available at www.pepperl-fuchs.com, or alternatively they can
be requested directly from the manufacturer.

Support

E-Mail: [e-mail]

Copyright© 2018 ecom instruments GmbH.
The contents of this document, either in part or in their entirety, may not be reproduced, forwarded, distributed
or saved in any way without ecom instruments GmbH prior written consent.

The contents of this document are presented as they currently exist. ecom instruments GmbH does not provide
any express or tacit guarantee for the correctness or completeness of the contents of this document, including,

but not restricted to, the tacit guarantee of market suitability or tness for a specic purpose unless applicable

laws or court decisions make liability mandatory. ecom instruments GmbH reserves the right to make changes
to this document or to withdraw it any time without prior notice.

Zone 1/21, Div. 1

Zone 2/22, Div.2 rugged

Note:

Please also observe the safety requirements in the specific
safety instructions and the information in the full user guide
for your device.

The documents can be downloaded from the

relevant product page at www.ecom-ex.com

DOCT-6426 | 01/2019

WEEE-Reg.-Nr. DE 934 99306

Subject to change without notice.

ecom instruments GmbH | Industriestraße 2 | 97959 Assamstadt | Germany

Phone [phone] | Fax [phone]

[e-mail] | www.ecom-ex.com

Intrinsically safe feature phone Ex-Handy 10

QUICK START GUIDE

THE NEXT GENERATION FEATURE PHONE FOR IIOT

1

Receiver

2

Proximity/Light sensor

3

Alarm key

4

Power key

16

1

How to insert the nano-SIM card

2

3

Step 1

To insert the nano-SIM card
unscrew the two cover screws in
a counter clockwise direction and
remove the SIM card cover.

5

Touchdisplay

6

Home key

7

Options key

8

Camera key

9

End Call/Reject

10

Loudspeaker

11

Magnetic USB port

12

Call/Accept

13

Back key

14

Volume keys

15

PTT key

16

Headset port

14

15

13

12

4

5

6

7

8

9

10

11

nano­SIM

Please use the screwdriver Torx
T8 provided with the device.

Step 2

Insert the nano-SIM card with
the gold-colored contacts facing
downwards by pushing it upward
in the designated slot.

Step 3

Reattach the SIM card cover
and screw down the two cover
screws in a clockwise direction.

Please use the screwdriver Torx
T8 provided with the device and
ensure not to overtighten the
screws.