Pepperl Fuchs CJ30-50K10-E0123-Y46139 Data Sheet
Capacitive sensor CJ30-50K10-E0123-Y46139
Technical Data
General specifications
Switching function Normally open/closed (NO/NC) switchable
Output type PNP/NPN
Rated operating distance sn30 mm
Installation flush
Output polarity DC
Model Number
CJ30-50K10-E0123-Y46139
Assured operating distance s
Output type 3-wire
Nominal ratings
Installation conditions
B
C
F
Operating voltage UB10 ... 30 V
Switching frequency f 0 ... 50 Hz
Hysteresis H typ. 20 %
Reverse polarity protection reverse polarity protected
Short-circuit protection pulsing
Vol tag e d rop U
Operating current I
Lowest operating current I
Off-state current I
No-load supply current I
Time delay before availability t
Switching state indicator Multihole-LED, yellow
Functional safety related parameters
MTTFd 554 a
Mission Time (TM) 20 a
Diagnostic Coverage (DC) 0 %
Ambient conditions
Ambient temperature -30 ... 60 °C (-22 ... 140 °F)
Mechanical specifications
Connection type cable PUR , 2 m
Core cross-section 0.25 mm
Housing material POM
Sensing face POM
Degree of protection IP67
Compliance with standards and directives
Stan dard conf ormit y
Sta ndar ds
Approvals and certificates
UL approval cULus Listed, General Purpose
CSA approval cCSAus Listed, General Purpose
0 ... 25 mm
a
0 mm
90 mm
100 mm
≤ 2.5 V
d
0 ... 150 mA
L
0 mA
m
0 ... 0.1 mA typ. 0.1 µA at 25 °C
r
≤ 15 mA
0
≤ 50 ms
v
2
EN 60947-5-2:2007
EN 60947-5-2/A1:2012
IEC 60947-5-2:2007
IEC 60947-5-2 AMD 1:2012
Dimensions
42
10
10 10
10 ± 0.30
50 - 0.50
5.5
8.2
3.5
4.2
LED YE
L
0 ... 90° 0 ... 90°
Release date: 2017-01-13 08:12 Date of issue: 2017-01-13 046139_eng.xml
Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.
1
Capacitive sensor CJ30-50K10-E0123-Y46139
Electrical Connection
BN
BK
BU
L+
L-
The switching state is indicated by LED visible
in three directions with the output function
break contact / make contact / PNP / NPN
freely configurable via rotary switch.
Adjustment:
The adjustment is via the flush mounted
adjustment potentiometer.
Change-over:
For the functional coding PNP/NPN and
break/make contact there is a rotary switch
each at the back of the sensor.
The adjustment is carried out by turning the
appropriate switch to the position corresponding to the switching function (ground stop).
Delivery state: E2 (PNP, make contact)
Break/make contact coding:
By turning 270 degree to the left the
change-over from PNP to NPN is achieved.
Installation Conditions
metal-free zone
sensing face
support
Connection diagrams:
CC
CC
B F
C
Release date: 2017-01-13 08:12 Date of issue: 2017-01-13 046139_eng.xml
Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.
2
Loading...