Page 1
R-01-01-080522
6EA
USER'S MANUAL
1. System power on by PS/2 Mouse: First, enable this function
in CMOS Setup, then you can power on the system by double
clicking the right or left button of your PS/2 Mouse.
2. System power on by Keyboard: If your ATX power supply
supports larger than 720 mA 5V Stand-By current, you can
power on your system by entering password from the
Keyboard after setting the “Keyboard power on” jumper (JP1)
and password in CMOS Setup.
3. Modem Ring-On (COM B).
4. Wake-up on LAN supports. (The ATX power supply supports
larger than 600 mA 5V Stand-By current)
5. Support 3 steps ACPI LED.
Pentium II Processor MAINBOARD
REV. 1.0 First Edition
Release Date: 98.04.24
Page 2
Page 3
6EA
1
The author assumes no responsibility for any errors or omissions which may
appear in this document nor does it make a commitment to update the
information contained herein.
Third-party brands and names are the property of their respective owners.
Sound Blaster is a registered trademark of Creative Technology Ltd in the
United States and certain other countries. Sound Blaster-LINK and SB-LINK
are trademarks of Creative Technology Ltd.
May 22, 1998 Taipei, Taiwan
Page 4
Quick Installation Guide
2
I. Quick Installation Guide :
CPU SPEED SETUP
The system bus speed can be selectable between 66.6MHz. The user can
select the system bus speed (JP2,JP3,JP4) and change the DIP SWITCH (SW)
selection to set up the CPU speed for 200 - 366MHz processor.
M
The CPU speed must match with the frequency RATIO. It will cause
system hanging up if the frequency RATIO is higher than CPU's.
DIP SWITCH (SW)
FREQ. RATIO
SW1 SW2 SW3 SW4
X 3
ON OFF ON ON
X 3.5
OFF OFF ON ON
X 4
ON ON OFF ON
X 4.5
OFF ON OFF ON
X 5
ON OFF OFF ON
X 5.5
OFF OFF OFF ON
MJP2, JP3, JP4 (Select the system speed¡Ð66.6 / 75 / 83 MHz )
MAIN CLOCK JP2 JP3 JP4
66MHz
1-2 1-2 1-2
75MHz
1-2 2-3 1-2
83MHz
2-3 2-3 2-3
«
Note: We don’t recommend you to setup up your system speed up
to 75 or 83MHz because they are not the standard spec. of
pheriphrals. If you want to run 75 or 83 MHz in your system
properly, it depends on your hardware configurations: CPU,
Page 5
6EA
3
SDRAM, Cards, etc.
1. Pentium II 233 / 66 MHz FSB
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
JP2
1
2
3
JP3
JP4
SW
ON
OFF
4 3 2 1
2. Pentium II 266 / 66 MHz FSB
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
JP2
1
2
3
JP3
JP4
SW
ON
OFF
4 3 2 1
Page 6
Quick Installation Guide
4
3. Pentium II 300 / 66 MHz FSB
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
JP2
1
2
3
JP3
JP4
SW
ON
OFF
4 3 2 1
4. Pentium II 333 / 66 MHz FSB
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
JP2
1
2
3
JP3
JP4
SW
ON
OFF
4 3 2 1
Page 7
6EA
5
5. Pentium II 366 / 66 MHz FSB
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
JP2
1
2
3
JP3
JP4
SW
ON
OFF
4 3 2 1
II. Jumper setting :
IR : Infrared Connector (Optional)
Page 8
Quick Installation Guide
6
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No. Function
1
2
IR Data Output
IR Data Input
3
GND
4
5
Signal
POWER (+)
1
PWR : Power LED
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No. Function
1
2
LED anode (+)
LED cathode (-)
3
LED cathode (-)
1
SPK : Speaker Connector
Page 9
6EA
7
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No. Function
1
2
VCC
NC
3
NC
4
Signal
1
TD : Turbo LED Connector
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Pin
No.
Function
1
2
LED anode (+)
LED cathode(-)
Page 10
Quick Installation Guide
8
TB : Turbo Switch Connector
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Pin
No.
Function
1
2
Signal
GND
RST : Reset Switch
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Open :
Normal operation.
Close :
Reset system
1
1
Page 11
6EA
9
GD : Green LED Connector
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Pin
No.
Function
1
2
LED anode (+)
LED cathode(-)
GN : Green Function Switch
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Open :
Normal operation.
Close :
Entering Green Mode
1
1
Page 12
Quick Installation Guide
10
HD : IDE Hard Disk Active LED
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Pin
No.
Function
1
2
LED anode (+)
LED cathode(-)
Soft PWR : Soft Power Connector
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Pin
No.
Function
1
2
Signal
GND
Open:
Normal
Operation
Short:
Power On/Off
POWER : Power Connector
Page 13
6EA
11
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No. Function
1
2,10,11,12
3
4
5,6,7,8
VCC (+5V)
GND
+12V
-12V
-5V9
Power Good
1
ATX POWER : ATX POWER Connector
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No.
Function
3,5,7,13,15-17
4,6,19,20
GND
10
12
18
8
+12V
-12V
-5V
VCC (+5V)
Power Good
9
14
5V SB
(Stand by +5V)
PS-ON
(Soft ON/OFF)
1
11
FAN PWR : CPU Cooling Fan Power Connector
Page 14
Quick Installation Guide
12
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
Pin
No.
Function
1
2
GND
+12V
SENSE
3
IDE1: For Primary IDE port
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
RED LINE
IDE2: For Secondary IDE port
Page 15
6EA
13
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
RED LINE
FLOPPY : FLOPPY PORT
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
RED LINE
LPT : LPT PORT
Page 16
Quick Installation Guide
14
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
RED LINE
COMB : COM B PORT
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
RED LINE
COMA : COM A PORT
Page 17
6EA
15
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
RED LINE
JP1 : Keyboard Power On (for ATX Power Supply only)
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1-2 close :
Enable Keyboard Power On.
2-3 Close :
Disable Keyboard Power On.
1
1
K.B : Keyboard Connector
Page 18
Quick Installation Guide
16
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No.
Function
1
2
3
4
5
Key Clock.
Key Data
NC
GND
VCC (+5V)
4
1
3
5
2
J7 : PS/2 MOUSE
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
1
RED LINE
USB : USB Port
Page 19
6EA
17
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No. Function
1
2
3
4
5
6
7
8
USBV 0USBV 0+
USBV1-
GND
VCC
GND
VCC
USBV1+
1234
876
5
Wake on Lan (for ATX Power Supply only)
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No. Function
1
2
3
GND
Signal
+5V SB
1
J10 : ATX Power Control Selection
Page 20
Quick Installation Guide
18
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No.
Function
1
2
GND
Open: Soft Off
Short: Full On
Signal
SB-LINK : For PCI Audio / Sound Card use only
(Creative PCI Sound Card Support)
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
Pin No. Function
1
2
GND
Signal
3
NC
4
Signal
5
GND
6
Signal
1
2
5
6
Page 21
6EA
19
BAT1 : For Battery
82443LX
PIIX4E
6EA
Intel
440EX
CPU
1
JP3
JP4
+
–
M Danger of explosion if battery is incorrectly replaced.
M Replace only with the same or equivalent type recommended by the
manufacturer.
M Dispose of used batteries according to the manufacturer’ s instructions.
III. Top Performance Test Setting:
The following performance data list is the testing results of some popular
benchmark testing programs.
Users have to modify the value for each item in chipset features as follow
for top performance setting.
Page 22
Quick Installation Guide
20
**
Each value of items as above depends on your hardware configuration :
CPU , SDRAM , Cards , etc.
Please modify each value of items If your system does not work properly .
Page 23
6EA
21
These data are just referred by users, and there is no responsibility for different
testing data values gotten by users. (The different Hardware & Software
configuration will result in different benchmark testing results.)
• CPU
Pentium II processor
• DRAM (32x 2) MB SDRAM (LGS GM72V661641CT7J)
• CACHE SIZE 512 KB included in CPU
• DISPLAY GA-601 AGP Display Card (4MB SGRAM)
• STORAGE Onboard IDE (Seagate ST36530A)
• O.S. Windows NT™ 4.0
• DRIVER Display Driver at 1024 x 768 x 64K colors x 75Hz.
TRIONES Bus Master IDE Driver 3.70
Intel Pentium II
Processor
266MHz(66x4) 333MHz(66x5)
Winbench98
CPU mark32 721 864
FPU Winmark 1380 1720
Business Disk 2100 2140
Hi-End Disk 5260 5420
Business Graphics 159 183
Hi-End Graphics 167 195
Winstone98
Business 29.4 32.8
Hi-End 31.6 35
Page 24
Loading...