CT8602
8
0
9
0
7
0
6
0
9
0
8
0
7
0
6
0
Installation Quick Guide
Your NEW thermostat may be programmed before or after installation (see reverse).
Items needed: three fresh AA alkaline batteries, pan head screwdriver,
drill, and level (optional).
1. Turn off Heating/Cooling system power.
2. Remove old thermostat from wall. Use enclosed labels to mark the wires as you
disconnect them. Label wires using letters above screw terminals, not wire colors.
3. Separate wallplate from new thermostat. Mount wallplate to wall with hardware
provided. Use level, if desired, and 3/16 in. drill bit in drywall or 7/32 in. drill bit in
plaster or wood.
4. Attach the system wires to matching screw terminals, using the label designations from
step 2. NOTE: If you have 5 wires remove factory installed jumper between R and Rc.
5. Install batteries into programmable thermostat.
6. Mount the thermostat to wallplate - insert top and snap in the bottom.
7. Set the thermostat System switch to Heat or Cool and the system will operate at
the factory programmed settings. See Programming Quick Guide (reverse) to
customize program.
Congratulations! You have finished installing your new Honeywell
programmable thermostat! For additional information refer to
Programming and Installation Instructions, visit our web site at
www.honeywell.com/yourhome, or call the 24-hour automated
information line at 1-800-468-1502.
B
RRCOWYG
W
Y
G
69-1643EF-1
R
Programming Quick Guide
Set Current Time and Day
Set Current
Press , , Time . Press to start built-in program.
Day/Time
Day
or
Run
Program
Customize Program
Press . Press then Time . Press or to set heating
Wake
temperature. Press to switch to cool mode. NOTE: Program times are the same for
Day
Heat/Cool
Settings
or
both heating and cooling. Press or to set cooling temperature.
Repeat these steps for , and .
Press when all the days are programmed.
Run
Program
Leave
Return
Sleep
Copying a Day
Press , to enter programming mode. Press to select the day you want to copy
from and press . Press to select the day you want to copy to and press .
Wake
Copy
Day
Day
Copy
Repeat these steps for each day.
For additional information, refer to the Programming and Installation Instructions, visit our web site at
www.honeywell.com/yourhome, or call the 24-hour automated information line at 1-800-468-1502.
69-1643EF–1 Rev. 03/04 Copyright © 2004 Honeywell International, Inc.
Printed in U.S.A. on recycled paper containing
at least 10% post-consumer paper fibers.
Loading...