Pentair Everpure CES-2750M-51 User Manual

B E N E F I T S

A P P L I C A T I O N / S I Z I N G

I N S T A L L A T I O N T I P S

O P E R A T I O N T I P S

CE S 275 0 Ser ies

Wate r C onditio ner

Water Conditioning fo r Co mmer cial and Lig ht I ndus trial Applications Available in Sing le T ank Syst em w ith 1” P orti ng

Hardness removal of 34,000 to 101,000 grains at flow rates up to 20 gallons per minute continuous

Meter initiated regeneration minimizes salt, water, and electrical costs

Advanced user-friendly controls incorporates time-tested hydraulically balanced piston, seal and spacer design to pilot service flow and regeneration

Large capacity brine tank maximizes time between refills

Locate equipment on a smooth, level surface

Maintain an air-gap at the end of the drain line

Secure drain line directly over floor drain or stand pipe

When connecting to a water heater, install a check valve on the soft water piping to prevent hot water back-up

When sweating/installing copper piping, protect the control valve from excessive heat

Check local codes for additional equipment that may be required, such as backflow prevention devices (i.e., RPZ)

CES-2750M-34: EV9982-21

MRS-20T System: EV9797-92

CES-2750

M-51: EV9982-22

CES-2750

M-68: EV9982-23

4MR-1 Cartridge: EV9273-6

CES-2750

M-101: EV9982-24

Check for softened water each time salt is added, by using a soap or hardness test kit

Use a good quality grade of salt -Solar or pellet are preferred

Check the salt level on a regular basis

Maintain at minimum salt depth of 6” to ensure a proper regeneration

On iron bearing waters, use a salt that contains an iron “fighting” additive, or use a resin cleaner on a regular basis

Check the water level in the brine tank If abnormally high - refer to IO guide for troubleshooting information

Fiberglass reinforced resin vessels with NSF approved polyethylene liners eliminate worries about corrosion

Single tank design for simplicity, economy and space savings

Fully adjustable 5-cycle control delivers controlled upflow backwash, downflow brining and slow rinse, rapid rinse, timed brine refill and downflow service

Warewashing

Laundry - Linen & Uniform

Boiler Scale Control

Water Heater Scale Protection/Reduction

General Housekeeping

Overall Dimensions (inches):

CE S 275 0 Ser i e s

CE S SE RI ES

WATER C ON D I T I ON E R

Model

Number

CES-2750M-34

CES-2750M-51

CES-2750M-68

CES-2750M-101

Width Depth Height

(A) (B) (C)

34 23 65 35 23 71 37 23 69 45 28 82

Inlet Connection: 1” MNPT

Outlet Connection: 1” FNPT

Service Flow Rate (GPM):

Model

Number

CES-2750M-34

CES-2750M-51

CES-2750M-68

CES-2750M-101

Cont. @

15 PSI DP

16 20 17 22 19 25 20 26

Rated Capacity (grains): CES-2750M-34 34,000 CES-2750M-51 51,000 CES-2750M-68 68,000 CES-2750M-101 101,000

Pressure Requirements: 25-100 PSI (1.7 -6.9 bar) non-shock

Peak @

25 PSI DP

Everpure water softening systems are covered by a limited warranty against defects in material and workmanship for the following periods:

◆Complete System - 1 year

◆Control Valve - 5 years

◆Mineral Tank(s) -

◆6-13” diameter - 10 years

◆14” diameter and larger - 5 years

See printed warranty for details. Everpure will provide a copy of the warranty upon request.

SSALGR

ETFO

REN

NAT

KNAT

The contaminants or other substances removed or

reduced by this water conditioning system are not

necessarily in your water. Do not use with water that is

microbiologically unsafe or of unknown quality

without adequate disinfection before or after the

system. Systems certified for cyst reduction may be used

with disinfected water that may contain filterable cysts.

Temperature: 40º F to 100º F

Electrical: 115 VAC/60 HZ/1 Phase

Shipping Weight: CES-2750M-34 120 lbs. CES-2750M-51 150 lbs. CES-2750M-68 190 lbs. CES-2750M-101 280 lbs.

Operating Weight: CES-2750M-34 670 lbs. CES-2750M-51 750 lbs. CES-2750M-68 850 lbs. CES-2750M-101 1410 lbs.

Everpure, LLC 1040 Muirfield Drive Hanover Park, IL 60133 Ph: 630-307-3000 Fax: 630-307-3030