PengTai Interactive Advertising S151015 User Manual

User Manual

Product Name: SuperT

Brand: SuperT

Model: SuperT_V2, SuperT

Manufacture: PengTai Interactive Advertising Co., Ltd.

FCC Warning
a、§15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.

b、§15.21 Changes or modification warning.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

c、§15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

d、RF warning for Portable device:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.

Technical details

Iterms

General Features

Model

SuperT_V2, SuperT

Brand

SuperT

Size

LED panel：209*239*6mm

Connection mode

Bluetooth 4.0

Power source

Portable powerbank（5V 2A）

Battery

2600mA powerbank could normally be used for 3h

LEDpanel

with evenly distributed LED lights

Iterms

Instructions

LED installation

Use the fastening tape to fix and install the LED panel.

Connection mode

Open the Bluetooth of your phone, keep the phone and
SuperT distance inside 10m.search and connect to the device.

Charging
instructions

It is recommended to use the official portable power bank.

Storage

Don’t fold or squeeze LED panel, and stored in a dry light
place.

Water
penetration

In case of rain, sweat soaking and water splashing, please

make sure it’s powered off and wipe it with a dry clean tower

and placeit in a dry light place. If more questions, please call
the customer service center.

Heating problem

Normally there will not be a heating problem when the device
is working for long. But if there is, please stop using the device
and contact us.

Notices