Pengo Dirt Aggressor Auger User Manual

COMPATIBILITY

COMPATIBILITY

Augers Compatible with BoRH Attachments

The BoRH™ is compatible with Aggressor® augers made with a
one- piece cast auger head. The auger head acts as the tooth
and pilot mounting platform. Below are things to look for when
determining if your auger is compatible with the BoRH™ system.

US Patent 7,669,673

• The height of the new pilot
adapter (Dimension A) is 2-1/2".
If this dimension is 1-1/2", then
the auger head was fabricated
and may not work well with the
BoRH™ attachment.

• If there is a weld bead in the
areas pointed out with B, then
the auger head was fabricated
and may not work well with the
BoRH™ attachment.

• The compatible 1 piece cast
auger head will have cast raised
lettering in Area C. The lettering
will have the auger diameter
followed by a “-AR”. Directly
below that will be a part number
that ranges from 137692

- 137697 depending on size.
If your auger does not have
those markings, then the Auger
Head was fabricated and may
not work well with the BoRH™
attachment.
NOTE: If the auger has
excessive wear, the lettering
may no longer be present. In
those cases, refer to A & B to
determine compatibility.

9” Dia. Auger

without teeth or pilot

Instructions to convert

PENGO Dirt Aggressor

®

Auger

Into a Rock Auger

C

9-AR

A

B

Bottom View of Auger

137693

Side View of Auger

1 pc. cast

auger head

US Patent 7,669,673

www.pengoattachments.com

800.599.0211

STEP ONE

STEP TWO

STEP THREE

REPLACING TEETH

STEP ONE

Remove Dirt Components

STEP THREE

Install Wear Caps

Remove the Pengo® TriFlow® Pilot Bit & 40/50 Teeth as shown by
removing 1/2" Nuts & Bolts with 3/4" wrench or socket.

Auger head without

pilot & teeth.

STEP TWO

Install Rock Head

Place Wear Caps onto Dirt/Rock Head as shown below. Make sure
that the holes in the wear caps line up with the holes in the auger
and rock head. Place 1/2" x 1-1/4" Hex Bolts into wear caps so
that the hex head seats in the hex recesses of caps. Tighten 1/2"
nuts onto bolts placed on underside of rock head with 3/4"
thin-walled socket.

REPLACING TEETH

Insert Cast Rock Head into Auger Head and secure into place with
1/2" Nut & Bolt through center of auger as shown below. Make
sure rock head is orientated so that the holes in the rock head line
up with the holes in the Auger head.

1/2" Bolt

Tighten Nut onto
Bolt with 3/4"
wrenches

NOTE: BoRH™ head comes with the P-21 RR tooth installed. To
replace teeth remove the worn teeth by using the Pengo® Drift
Punch tool to pop teeth out of holders. Insert the P-21 RR tooth
into the cylindrical holders of the cast head and secure by using the
Pengo® SH-85 soft hammer.

Description Part No.

6-BORH Auger Kit 137991
9-BORH Auger Kit 137992
12-BORH Auger Kit 137993
15-BORH Auger Kit 137994
18-BORH Auger Kit 137995
24-BORH Auger Kit 137996
P21-RR Carbide tooth 137990
1225 Drift Punch 137750
SH85 Soft Hammer 137737