Pelco WV-NP244, WV-NP304 User Manual

Release Notes

Panasonic IP Cameras Supported on Digital Sentry

Integral Digital Sentry® digital video management systems (DVMS) support certain Panasonic with Digital Sentry IP camera driver version 6.8.0.126 and later. Refer to each camera’s table for information about the hardware and software features validated for use on a Digital Sentry system. Any general limitations or special instructions are listed at the beginning of the document, and any model-specific information is listed after each table. For information about the general usage of each camera, refer to the camera manufacturer’s documentation.

To obtain the latest IP camera driver or documentation for use with Digital Sentry, refer to the Pelco Web site at

General Panasonic IP Camera Notes

• If the frame rate is set to a value larger than the maximum value for a camera, the frame rate defaults to the maximum value.

IP camera models. The camera models listed in this document can be used

www.pelco.com

• Frame rates are rounded up to the next value listed in the tables. For example, if the requested frame rate is 8 frames per second (fps), the camera provides 10 fps.

• Because of a limitation regarding the number of users viewing feeds from the camera, the frame rate requested might not match what the camera can supply at that time. The camera automatically logs off users who are not actively using the feeds, which then increases the total throughput for remaining users.

• Frame rates could be reduced as quality settings are increased.

• All camera-specific Panasonic drivers have been replaced by a single Panasonic i-Pro driver in DSAdmin.

• To capture images larger than 2 MP, you must install Integral IP camera driver 6.7.0.5 or later and then Megapixel Support for DS Server/VAU 4.1. To obtain a copy of all necessary software versions, go to

• To view images larger than 2 MP, you must install Megapixel Support for DS Client/ Admin 4.1 and DS ControlPoint 6.5.1.28 or later. To obtain a copy of all necessary software versions, go to

www.pelco.com

C1009RN (9/08) Page 1 of 6

Panasonic WV-NF302

Firmware 1.05E0_1.06

Supported Resolutions 1280 x 960 (MJPEG only),

640 x 480, 320 x 240

FPS 1–30

Number of Quality Settings MJPEG: 10

MPEG-4: 9

Supported Codec MJPEG, MPEG-4

Supported Motion Detection Integral

Pan/Tilt/Zoom (PTZ) Not available

Panasonic WV-NP244

Firmware 1.23

Supported Resolutions 640 x 480, 320 x 240

FPS 1–30

Number of Quality Settings MJPEG: 10

MPEG-4: 3

Supported Codec MJPEG, MPEG-4

Supported Motion Detection Integral

Pan/Tilt/Zoom (PTZ) Not available

Panasonic WV-NP304

Firmware 1.05E0_1.06

Supported Resolutions 1280 x 960 (MJPEG only),

640 x 480, 320 x 240

FPS 1–30

Number of Quality Settings MJPEG: 10

MPEG-4: 9

Supported Codec MJPEG, MPEG-4

Supported Motion Detection Integral

Pan/Tilt/Zoom (PTZ) Not available

Page 2 of 6 C1009RN (9/08)

+ 4 hidden pages