Pelco SRXV-CM installation manual

SRXV-CM

Mechanical Drawings

Corner Mount

Installation Guide

C6692M

Package Contents

Items 1. Corner mount bracket, 2. M6X20mm screws x4. 3. M5X20mm screws x4, 4. Hex L

NOTE: Attachment without a conduit box is less recommended due to the lack of waterproof

and cabling protection. If directly attached, you should properly wrap the read-end cables and
connectors with waterproof protection such as putties.

wrench 5mm x1, 5. Hex L wrench 4mm x1, 6. M8 nut x2. 7. M4x15 screws x4

M4X15

X4

M6X20

5mm X1

X4

M5X20

4mm X1

X4

M8

X2

SRXV-CM Corner mount

215,71

M8X20mm
SUS 302

175

4- 6

4- 7

3- 4,5

45

56,29

86

102

315,25

144,17

86

170

102

48,75

4. Secure the conduit box, wall arm, or bullet camera to bracket using the screws, washers, and hex heads. A
hex crescent wrench is required.

Installation

Below is a general, sample procedure using a Corner mount bracket:

1. Combine the two metal pieces together using the M8 hex nuts and washers.

2. Align the assembled brackets with the desired position. Align screw holes on the brackets against the wall. Drill
holes on the wall for securing the bracket and for routing the cables. Hammer the anchors into the wall. Note
that these screws and wall anchors are user-supplied.

x8

3. Hole congurations:

5. For the rest of the installation procedure, refer to the documentation that came with the other accessories.

The 3/4" cable glands and conduts for protecting cables are user-supplied.

Four M5 socket screws

- For SRXV-WMP Wall Mount
directly attached.

Three M4 screws

- For IBV Series
directly attached.

Four M5 socket screws

- For conduit box.

Pelco, Inc.

625 W. Alluvial, Fresno, California 93711 United States

USA & Canada Tel [phone] Fax [phone]
International Tel [phone] Fax +1 (55() 348-1120
www.pelco.com