INSTALLATION
SPM5-W/SPM5-B
Pendant Mount
Indoor Only
C2222M-A (2/18)
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Only use attachments/accessories specified by the manufacturer.
6. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
7. Installation should be done only by qualified personnel and conform to all local codes.
8. Use only installation methods and materials capable of supporting four times the maximum specified load.
9. Use only replacement parts recommended by Pelco.
Description
The SPM5-W/SPM5-B pendant mount is specifically designed for the Spectra® Mini dome system.
The mount is compatible with 0.75-inch NPT pipe or 20 mm threaded conduit.
Installation
To install the SPM5-W/SPM5-B pendant mount:
1. Attach the mount to either 0.75-inch NPT pipe or 20 mm threaded conduit.
2. Bring wiring through the pipe/conduit and mount. Refer to Figure 6, Table D, Table E, and Table F in the installation manual for the Spectra Mini dome for wiring information.
3. Install the Spectra Mini dome in the mount. Follow the instructions in the Switch Settings and
Hard Ceiling installation sections of the installation manual for the Spectra Mini dome system.
In the Hard Ceiling section, disregard step 2 about cutting holes in the ceiling.
In step 5 of the same section, attach the dome drive to the mount with the two
8-15 x 0.75-inch screws that are supplied with the mount.
2 C2222M-A (2/18)
Specifications
Ø 6.10
(15.49)
3.95
(10.03)
MECHANICAL
Mounting Method Attach the mount to 0.75-inch NPT pipe or 20 mm threaded conduit; attach
GENERAL
Construction ABS plastic
Finish White (SPM5-W) or Black (SPM5-B)
Weight 0.30 lb (0.14 kg)
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES.
Spectra Mini dome with the hardware supplied with the mount.
The materials used in the manufacture of this document and its components are compliant to the
requirements of Directive 2002/95/EC.
C2222M-A (2/18) 3
Loading...