Pelco SPA102, PA102, PA101 User Manual

INSTALLATION

PA100/PA101/PA102/
SPA102
Pole Mount Adapters

C250M-E (12/05)

Important Safety Instructions

Prior to installation and use of this product, the following WARNINGS should be observed.

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Only use attachments/accessories specified by the manufacturer.

6. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury from tip-over.

7. Installation should be done only by qualified personnel and conform to all local codes.

8. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is designed for indoor use only and it must not
be installed where exposed to rain and moisture.

9. Use only installation methods and materials capable of supporting four times the maximum specified load.

10. Use stainless steel hardware to fasten the mount to outdoor surfaces.

11. CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform
any servicing other than contained in the operating instructions unless you are qualified to do so.

Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.

Description

The PA100/PA101/PA102 pole mount adapters are designed to permit the use of standard wall mounts when installation of CCTV equipment is
required on a pole. A Coaxitron
The SPA102 pole mount adapter is used in conjunction with the PA102 and ST1 support strut in installations requiring additional support for the
WM2000 wall mount. The PA102, when used with the SPA102 and ST1, will support loads up to 150 pounds (68 kg).

Pole mount adapters are available to mount a variety of wall mounts on poles. All pole mount adapters are supplied with stainless steel straps
for fastening the adapters to poles. Stainless steel hardware also is provided for attaching mounts to the adapters. Lightweight, rugged, and
easy to install, the pole mount adapters are constructed of aluminum and have a gray polyester powder coat finish.

MODELS

PA100 Pole mount adapter for use with the EM22 mount. Mounts on poles having 1.5-inch (3.81 cm) to 8-inch (20.32 cm) diameters.

PA101 Pole mount adapter for use with the CM1450, EM1400, EM1450, PM14, and MM1000 mounts. Mounts on poles having 3-inch

PA102 Pole mount adapter for use with the WM2000 wall mount. Mounts on poles having 3-inch (7.62 cm) to 8-inch (20.32 cm)

SPA102 Pole mount adapter for use with the ST1 support strut in installations requiring additional pole mount support for the WM2000

®

outdoor receiver or WLVEH enclosure can also be mounted to a PA102 when used with the PA9000 adapter.

(7.62 cm) to 8-inch (20.32 cm) diameters.

diameters. A Coaxitron outdoor receiver or WLVEH enclosure can be mounted to a PA102 when used with the PA9000 adapter.

wall mount. Mounts on poles having 3-inch (7.62 cm) to 8-inch (20.32 cm) diameters.

2 C250M-E (12/05)