Sarix® IBP-PLMT Pole Mount Adapter
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Follow these instructions.
4) Installation should be done by qualified personnel and conform to all local codes.
5) Use only installation methods and materials capable of supporting four times the maximum specified load.
6) Use stainless steel hardware to fasten the mount to outdoor surfaces.
Description
The IBP-PLMT pole mount adapter is engineered for use with all Sarix® IBP Series Environmental cameras. It
can be installed on a horizontal/vertical pipe or pole that has a diameter of 7.62 cm (3 in.) to 20.32 cm (8 in.).
Parts List
The following parts are supplied:
Qty Description
1 IBP-PLMT pole mount adapter
2 Stainless steel straps
4
6 Torx M4 x 14 mm, T20 tamperproof screws
5 Torx 8-32 x 0.75, T20 tamperproof screws
®
Tor x
8-32 x 0.375, T20 tamperproof screws
The following parts are required but not supplied:
Qty Description
1 Sarix IBP Series Environmental Bullet Camera
1 Torx T20 bit driver, tamperproof
1 Surface mount back box with adapter plate, part no. IBPBBAP-ES
INSTALLATION MANUAL
C2273M | 2/15
Installing the IBP-PLMT Indoors Without a Surface Mount Back Box
6, 7
8, 9
3, 4
1
2
5
The IBP Series camera mounts directly on the pole mount adapter using five Torx 8-32 x 0.75, T20 tamperproof
screws (supplied). Camera and network cable connections are managed behind the adapter.
Figure 1: Indoor Installation Without a Surface Mount Back Box
Installing the IBP-PLMT Indoors/Outdoors With a Surface Mount
Back Box
An adapter plate and surface mount back box are installed on the pole mount adapter as shown below. The
Sarix IBP Series Environmental Bullet Camera mounts on the back box lid and is attached to the back box. The
camera cable connections are made and contained inside the back box.
Figure 2: Indoor/Outdoor Installation with IBPBBAP-ES Surface Mount Back Box
1 Attach the IBPBBAP-ES surface mount back box adapter plate to the IBP-PLMT pole mount adapter using
four 8-32 x 0.375 screws (supplied).
2 Place the IBPBBAP-ES surface mount back box on the adapter plate standoffs, and then secure with the
three screws supplied with the back box.
Loading...