Pelco RMQ17T User Manual

®

Installation/Operation

RMQ14T/RMQ17T
Rack Mount Kit

C1996M (2/01)

Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.com
In North America and Canada: Tel [phone] • FAX [phone]

International Customers: Tel [phone] • FAX [phone]

IMPORTANT SAFEGUARDS AND WARNINGS

Prior to installation and use of this product, the following WARNINGS should be observed.

1. Installation and servicing should only be done by qualified service personnel and conform to all local codes.

2. Only use replacement parts recommended by Pelco.

3. Use only installation methods and materials capable of supporting four times the maximum specified
load.

Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.

DESCRIPTION

The RMQ14T/RMQ17T Rack Mount Kit is designed to mount a single monitor to any standard 19-inch
(48.26 cm) wide console or rack configuration. The RMQ14T is specifically designed for Pelco’s
PMCS14A, 14-inch super-high resolution monitor. The RMQ17T is designed for Pelco’s PMCS17A, 17­inch super-high resolution monitor.

INSTALLATION

RMQ14T

The RMQ14T Rack Mount Kit contains the following parts:

Qty Description

2 Monitor mounting brackets
2 Handles
8 Nylon finishing washers (black)
8 Screws, 10-32 x .75-inch, Phillips, pan head (black)
8 Screws, 10-32 x .50-inch, Phillips, pan head
8 Locking washers
4 Flat washers

To rack mount the PMCS14A monitor, refer to Figure 1 and do the following:

1. Disconnect the monitor from its power supply.

2. Attach the handles to the mounting brackets. Use four of the 10-32 x .50-inch screws and locking
washers.

3. Remove the three screws from the left side of the monitor and the three screws from the right side.

4. Use the hardware supplied with the rack mount kit and attach the monitor mounting brackets to the
sides of the monitor. Use two 10-32 x .50-inch screws, locking washers, and flat washers on each side.

5. Use the eight supplied 10-32 x .75-inch black screws and finishing washers and mount the monitor
assembly to a 19-inch (48.26 cm) rack or console. Installation of the monitor assembly may require
two persons.

6. Reconnect the monitor to its power supply.

[

]

2

Pelco Manual C1996M (2/01)