Pelco RMA14E-GY User Manual 2
®
RMA14E-BK/RMA14E-GY
Rack Mount Kit
Installation/Operation Manual
Manual C905M (2/96)
1.0 WARNINGS
Prior to installation and use of this product, the following
WARNINGS should be observed.
1. Installation and servicing should only be done by
Qualified Service and Installation Personnel.
2. Installation shall be done in accordance with all
local and national electrical and mechanical codes
utilizing only approved materials.
3. Use only installation methods and materials capable
of supporting four (4) times the maximum specified
load.
2.0 SCOPE
The information within this manual covers the installation
of the RMA14E-BK and RMA14E-GY Rack Mount Kits.
Installation should be in accordance with all applicable
local and national electric codes, utilizing approved
materials only.
Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.
3.0 DESCRIPTION
The RMA14E-BK and RMA14E-GY Rack Mount Kits
are designed to provide rack mounting for a single Pelco
PMC14E monitor.
This versatile rack will fit any standard 19 inch wide
console or rack configuration and is available in a black
(RMA14E-BK) or gray (RMA14E-GY) finish.
Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981
FAX (800) 289-9150 or (1-559) 292-3827
4.0 SPECIFICATIONS
Dimensions: See Figure 1
Construction: 14-gauge steel
To install the rack kit and monitor, perform the following steps:
1. Assemble the rack as shown in Figure 2 using the
supplied hardware.
Finish: Black or gray polyester powder coat
Weight: 9.31 lbs. (4.21 kg)
5.0 INSTALLATION
The rack kit is supplied unassembled. The following
hardware is provided for use in assembling the rack kit.
Qty Description
8 8/32 Hex nuts
8 #8 Lock washers
While assembling, install all hardware loosely until all components are attached and then finish by
tightening all hardware.
2. Set the monitor into the rack, aligning the four (4)
feet with the holes in the base plate.
3. Install rack and monitor as an assembly into console and make any required electrical connections.
4. Hold into place, aligning mounting holes of the
rack kit with mounting holes in console, and insert
and tighten required fasteners (not supplied).
14.08
(35.75)
19.00
(48.26)
14.08
(35.75)
47°
2.19
(5.55)
.38
(.95)
13.25
(33.67)
NOTE: THE VALUES IN PARENTHESES ARE CENTIMETERS;
ALL OTHERS ARE INCHES
13.88
(35.24)
(35.56)
14.00
Figure 1. RMA14E Series Dimension Drawing
2 Pelco Manual C905M (2/96)
Loading...