Pelco RMA13 User Manual
C985M
INSTALLATION MANUAL
MODEL RMA13 RACK MOUNT KIT
®
1.0 SCOPE
The information within this manual covers the installation of the RMA13 Rack Mount Kit.
Installation should be in accordance with all applicable
local and national electric codes, utilizing approved materials only.
Please thoroughly familiarize yourself with the information in this manual prior to installation and operation.
2.0 DESCRIPTION
The RMA13 Rack Mount Kit is designed to provide rack
mounting for a single PELCO PMM13 or PMM13-X
monitor.
This versatile rack will fit any standard 19 inch wide
console or rack configuration.
3.0 SPECIFICATIONS
Dimensions: See Figure 1
Construction: 16-gauge steel
Weight: 4 lbs 15 oz.
Figure 1. RMA13 Dimension Drawing
PELCO Manual C985M - 1/94 1
4.0 INSTALLATION
The RM13 rack kit is supplied unassembled. The following hardware is provided for use in assembling the
rack kit.
Qty Description
6 10/32 Hex nuts
6 #10 Lock Washers
To install the rack kit and monitor, perform the following steps:
1. Assemble the rack as shown in Figure 2 using the
supplied hardware.
While assembling, install all hardware loosely until all components are attached and then finish by
tightening all hardware.
2. Slide the monitor into the rack, tight against the rear
stop.
3. Install rack and monitor as an assembly into console and make any required electrical connections.
4. Hold into place, aligning mounting holes of the
RMA13 with mounting holes in console, and insert
and tighten required fasteners (not supplied).
PELCO Manual C985M - 1/94 2
Loading...