Pelco POE1XT Specsheet

PRODUCT SPECIFICATION
transmission and power
POE1XT Single-Port PoE Gigabit Extender
EXTENDS POWER OVER ETHERNET AND ETHERNET DATA TO 200 METERS
Powered by an IEEE802.3at Source
Output is IEEE802.3af Compliant
Fully Compliant 25K Signature Resistance Detection
(IEEE802.3at and IEEE802.3af)
Boost Circuit to Compensate for Wire Drops
Diagnostic LEDs
Full Protection
– Over Current Protection (OCP)
– Short Circuit Protection (SCP)
Extends Ethernet to 200 Meters (656.17 Feet)
The POE1XT is a single-port Power over Ethernet (PoE) Gigabit extender that is designed to meet the demanding data rate and power requirements of IP cameras with high-quality streaming video capabilities. The POE1XT provides a voltage boost to the PoE adding another 100 meters to extend Ethernet to 200 meters (656.17 feet).
The POE1XT Gigabit extender accepts power from an IEEE802.3at source and is 25K signature resistance detection IEEE802.3at input compliant. DC input voltage range is 45 to 57 VDC. DC input current at maximum load is 1.0 A at 45 VDC and 0.8 A at 57 VDC. Total output power is 19 W with a 33.6 W PoE input and is 25K signature resistance detection IEEE802.3af output compliant.
IEEE802.3AT
SWITCH OR MIDSPAN
IMPORTANT NOTE: PLEASE READ. The network implementation shown is a general representation depicting the 100 meter (328 feet) limit of PoE from the switch or midspan to the extender. It also depicts the additional 100 meters (328 feet) the extender provides to the powered device extending PoE to 200 meters (656.17 feet). Note that the POE1XT is powered by an 802.3at source and supplies an 802.3af output. Contact the local Pelco representative to discuss specific application requirements.
100 METERS POE
DATA
POE1XT
100 METERS POE
DATA
IEEE802.3AF
DEVICE
International Standards
Organization Registered Firm;
ISO 9001 Quality System
C3964 / NEW 9-13-13
TECHNICAL SPECIFICATIONS
MODEL
POE1XT Single-Port PoE Gigabit extender powered by
IEEE802.3at source
ELECTRICAL
Input (802.3at)
Input Source Receives power from an IEEE802.3at source Input Detection 25K detection IEEE802.3at compliance DC Input Voltage Range 45 VDC to 57 VDC DC Input Current 1.0 A at 45 VDC and maximum load
0.8 A at 57 VDC and maximum load
Output (802.3af)
Total Output Power 19 W with 33.6 W PoE input DC Output Voltage 54 V minimum, 56 V typical, 57 V maximum Output Current 10 mA minimum, 330 mA maximum Ripple and Noise (Vp-p) 250 mV maximum Output Detection 25K detection IEEE802.3af compliance Efficiency 75% minimum at maximum load Short Circuit Protection Outputs equipped with short circuit
protection; the output can be shorted permanently without damage
Over Current Protection 450 mA maximum for PoE Class 0-3 detection
on output
Power Consumption
Power Consumed by POE1XT 5 W maximum
Connection
Input/Output Connectors RJ-45 Input Connection
GND Pins 1,2 7,8 +VIN Pins 3,6 4,5
Output Connection
GND Pins 1,2 +VIN Pins 3,6
FRONT PANEL INDICATORS/FUNCTIONS
Ethernet IN/OUT
Status/Color Description
Green LED1 and LED2 10 Megabit (Mb) activity
Green LED1 100 Mb activity
Green LED2 1 Gigabit (Gb) activity
Orange LED3 Link activity
PoE
Status/Color Description
Blinking Green Unit is powered ON with no active load
Solid Green Unit has detected a valid IEEE802.3af load
Blinking Red/Green Unit has detected an invalid load
Solid Red Unit is in over-load condition
ENVIRONMENTAL
Operating Temperature
Megabit Data Rates at
10 Mb and 100 Mb 0° to 55°C (32° to 131°F)
Gigabit Data Rates 0° to 40°C (32° to 104°F) Storage Temperature –25° to +65°C (–4° to 149°F) Maximum Humidity Gradient 5% to 90% Immunity
ESD EN61000-4-2, Level 3
RS EN61000-4-3, Level 3
Surge EN61000-4-5, Level 2 Isolation (HI-POT) 2,121 VDC for 1 minute, 10 mA
Insulation Resistance
Input to Ground >10 MOHM 500 VDC
Output to Ground >10 MOHM 500 VDC
CERTIFICATIONS
• CE, EN55022 Class A
• FCC, Part 15, Class A
Pelco by Schneider Electric
3500 Pelco Way, Clovis, California 93612-5699 United States
USA & Canada Tel (800) 289-9100 Fax (800) 289-9150 International Tel +1 (559) 292-1981 Fax +1 (559) 348-1120 www.pelco.com www.pelco.com/community
VALU ES IN PARENTHESES ARE INCHES; ALL OTHERS ARE CENTIMETERS.
15.0
(5.91)
12.0
0.89
(0.35)
(4.72)
0.33 (0.13)
Pelco, the Pelco logo, and other tradema rks associated with Pelco products refer red
to in this publication are trademarks of P elco, Inc. or its affiliates. ONVIF and the
ONVIF logo are trademarks of ONVIF Inc. All other pro duct names and
Product specifications and availability are subject to change without notice.
3.2
(1.26)
6.0
(2.36)
services are the property of their respective companies.
©Copyright 2013, Pelco, Inc. All rights reserved.
Loading...