Sarix® Value Series IREnvironmental
Bullet Cameras
Installation Manual
Document number:C6673M
Publication date:05/21
Sarix® Value Series IREnvironmental Bullet Cameras Installation Manual
Table of Contents
Overview 3
Package Contents 3
POE Requirements 3
Physical Description 4
Outer View 4
Inner View 4
Installing the Hardware 5
Accessing the Camera 9
Supplemental Resources 10
Configuring the Password 10
Adjusting Pan, Tilt, and Rotation 11
Deploying the Camera on a Network 13
Using a PoE-enabled Switch 13
Using a Non-PoE Switch 13
Verifying the Installation 13
Connecting to the Internet Via a Router 14
Troubleshooting 15
Performing a HardwareReset 15
Pelco Troubleshooting Contact Information 16
C6673M | 05/21
2
Sarix® Value Series IREnvironmental Bullet Cameras Installation Manual
Overview
Sarix Value IBV Bullet Series cameras are ideal for overt surveillance that can help deter criminal activity.
The Sarix Value Series features excellent image quality with great low light performance, color fidelity and
true wide dynamic range (WDR) for increased visibility in difficult lighting situations. And with built-in IR
illumination, the camera can provide coverage even in total darkness. The vari-focal lensing gives you the
flexibility to set a range of fields of view.
With IP66 rated ingress protection, the Sarix Value IBV Bullet Series can be deployed in a variety of indoor
and environmental settings.
Package Contents
l IBV229-1ER / IBV529-1ER
l Screw pack and side lid
l Sunshield and screw
l Quick Installation Guide
l Waterproof cable gland
POE Requirements
1. The camera is only to be connected to PoE networks without routing to outside plants.
2. For PoE connection, use only UL listed I.T.E. with PoE output.
Use the camera only with a PoE source power supply that is UL listed, and limited power source (LPS)
certified. The power supply should bear the UL listed and LPS marks. The power supply should also meet
any safety and compliance requirements for the country of use.
C6673M | 05/21
3
Sarix® Value Series IREnvironmental Bullet Cameras Installation Manual
Physical Description
Outer View
Inner View
C6673M | 05/21
4
Sarix® Value Series IREnvironmental Bullet Cameras Installation Manual
T10
64GB
10
I
1
Reset
button
Installing the Hardware
1. Write down the MACaddress of the camera for later use.
2. Open the hatch at the bottom of the camera, and install a MicroSD card if onboard storage is
desired.
C6673M | 05/21
5
Sarix® Value Series IREnvironmental Bullet Cameras Installation Manual
Ø ≥25mm
5
.5 ~ 6.4mm
3. Use the alignment sticker to drill mounting holes on the wall or ceiling. Drill a cabling routing hole if
preferred.
4. Route an Ethernet cable through the cabling hole.
5. Pass an Ethernet cable through the waterproof cable gland components, and through the rubber seal
as shown below. Connect the Ethernet cable to the camera's RJ45 connector.
C6673M | 05/21
6
Loading...