• Power over Ethernet (PoE) Class 3, 24 VAC, ± 10%, 12 VDC
• Pelco Smart Compression Technology
• Vandal resistant to IK10+ 50 joule, IP66 ingress protection
• Compatible with Pelco and third-party video systems
• ONVIF Profile S, Profile G, and Profile Q conformant
• Full 3-Year warranty and support
• Digital audio
• 940 nm IR (no glow)
Corner-Mount, Vandal-Resistant Design
The Sarix IBD Series High-Security Corner-Mount Camera is
designed for use in protected, high-risk areas. It features an antiligature, no-grip design without anchor points, and fits flush to
corners protecting against attempts to detach or disable the camera.
Despite sitting flush to a single corner, the camera's 45º angled
position allows it to capture video for an entire 10 by 10 m (32.8 x
32.8 ft.) room, including directly below the camera. The camera
provides high, 3 megapixel resolution imaging sensor and IR
illumination, allowing you to capture high quality video in high-risk
areas under any lighting condition.
Camera
The Sarix IBD Series indoor and outdoor corner mount cameras
feature a fixed lens for wide angle or long range surveillance needs.
Additionally, the Sarix IBD Series features advanced color science,
a mechanical IR cut filter, and advanced integrated adaptive (940 nm
no glow) IR illumination for increased sensitivity in low-light
installations.
Video
Sarix IBD Series cameras support up to two simultaneous video
streams and a third service stream. The two streams can be
compressed with efficient H.264 High or Main profiles or MJPEG
formats. The streams can be configured to a variety of frame rates
and bit rates to optimize image quality with bandwidth and storage
efficiency.
Edge Storage
Sarix IBD Series cameras feature onboard edge storage with a
micro SD card. Video clips of varying lengths can be stored to the
card upon alarm, or video can be written continuously to the SD card
in the case of network outage. Video can be retrieved from the card
through the FTP protocol or by using an ONVIF Profile G enabled
client.
Sarix IBDSeries cameras feature simple motion detection
algorithms allowing the camera to record or send an alarm when
there is motion detected in a selected zone or with the entire scene.
A camera sabotage alarm is triggered if the lens is obstructed.
Open and Integrated
Sarix IBD Series cameras seamlessly connect to Pelco video
management systems such as VideoXpert™, Endura® version 2.0 (or
later), and Digital Sentry
cameras integrate with major third-party systems through the ONVIF
Profile S, Profile G, and Profile Q standards.
®
version 7.3 (or later). Sarix IBD Series
Standard Web Interface
Pelco cameras use a standard Web browser interface for easy
remote setup and administration. Controls are optimized for
convenient one-step camera configuration for features including
color, exposure, flicker control, and streaming.
Dynamic Range75 dB
White Balance Range2,000° to 10,000°K
3D Digital Noise ReductionYes (ON/OFF selectable)
Signal to Noise Ratio±50 dB
Minimum Illumination
Mechanical IR Cut Filter Yes (AUTO/MANUAL selectable), with
IR IlluminationAdaptive IR up to 10 m; auto ON in night
MPxSensitivity
3 MPxf/2.10.2 lux0.02 lux0.00 lux0.00 lux
1 MPxf/2.10.2 lux0.02 lux0.00 lux0.00 lux
different set points on lux
mode, or OFF, 940 nm IR (no glow)
33 ms200 ms33 ms200 ms
LENS
Lens typeBuilt-in; fixed focal length
Focal Length1.8 mm
Field of View*Lens
1.8 mm
*Field of view may vary with changes
in resolution settings.
Angle of
View
Horizontal115°120°
Vertical86°90°
ColorMono - with IR Illumination
1 MPx3 MPx
TECHNICAL SPECIFICATIONS
VIDEO
Video StreamsUp to 2 simultaneous streams, plus service stream; the secondary stream is variable based on the setup of the primary stream
Text OverlayCamera name, time, date, and customizable text with multiple languages supported
Note: Available frame rates are selectable for each independent stream depending on the coding, resolution, and stream
configuration.
Video EncodingH.264 High, Main, and Baseline profiles; and MJPEG
Bit Rate ControlConstant bit rate (CBR), constrained variable bit rate (CVBR) with configurable maximum value
Corridor ModeElectronic image flip and mirror: 180°, 90° and 270° (H.264 only)
Service Stream640 x 480 or 640 x 352; 2 ips, JPEG
Window Blanking8 configurable windows
PELCO’S SMART COMPRESSION TECHNOLOGY
Pelco’s Smart Compression Technology lowers bandwidth and storage
requirements by up to 70%. Our technology allows the user to make
intelligent decisions regarding storage savings and image quality.
Pelco’s Smart Compression Technology dynamically analyzes motion
occurring within live video in real-time, to intelligently compress the
information you don’t need, while retaining details with clear quality in the
areas that are important in the scene. By enabling Dynamic GOP, an added
feature of Smart Compression, the number of I-frames are automatically
reduced in scenes with low motion. Based on the complexity of scenes and
motion occurring, such as a store room that has limited entry and exit, up to
70% bandwidth savings can be achieved.
AUDIO
StreamingBi-directional
InputLine In/Line Out terminal block
EncodingG.711 U-law
MicrophoneBuilt-in digital microphone
Type 4X
Vandal ResistanceIK10+ (50 Joule)
FinishRAL 9003
Unit Weight1.15 kg (2.54 lb)
Shipping Weight1.75 kg (3.86 lb)
ELECTRICAL
Network PortRJ-45 connector for 10/100Base-TX
Power InputPoE (IEEE 802.3af, Class 3); 24 VAC± 10%,
12 VDC± 10%
Power Consumption
Heater ONHeater OFF
12 VDC12.8 W11.9 W
With IR ON
With IR OFF
Local StorageUp to 128 GB on Micro SDHC or Micro SDXC
Alarm
Input1
Output1; PhotoMOS
TriggersUnsupervised mode that detects switch
24 VAC9.5 W8.7 W
PoE9.2 W8.3 W
12 VDC9 W8.1 W
24 VAC6.9 W6.1 W
PoE6.8 W5.9 W
card
™
relay (30 V, 1 A)
closures (N.O. and N.C.)
ENVIRONMENTAL
Operating Temperature–10° to 55°C (14° to 131°F)
Storage Temperature –40° to 60°C (–40° to 140°F)
Operating Humidity0% to 90%, RH condensing
Storage Humidity0% to 90%, RH noncondensing