Pelco EPM, ECM100, EPP User Manual

Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com

USA & Canada • Tel: [phone] • Fax: [phone]

International • Tel: [phone] • Fax: [phone]

Pelco, the Pelco logo, Spectra, Genex, Esprit, Camclosure, and Legacy are registered trademarks of Pelco. ©Copyright 2004, Pelco. All rights reserved.

C225M-C (11/04)
Esprit

®

Mounts

EWM, EPM, ECM100, and EPP

®

Important Safety Instructions

1. Installation and servicing should only be done by qualified service personnel and conform to all local codes.

2. Use only installation methods and materials capable of supporting four times the maximum specified load.

3. Use stainless steel hardware to fasten the mount to outdoor surfaces.

4. To prevent damage from water leakage when installing a mount outdoors on a roof or wall, apply sealant around the bolt holes between the mount
and mounting surface.

Description

This manual contains the installation instructions for the following Esprit

®

mounts:

EWM Wall Mount Use to mount an Esprit system directly to a load bearing vertical surface.

EPM Pole Mount Use in conjunction with the EWM to mount an Esprit system to a pole.

ECM100 Corner Mount Use in conjunction with the EWM to mount an Esprit system to a building corner.

EPP Pedestal Adapter Use to mount an Esprit system directly to a pedestal mount.

Installation

EWM ESPRIT WALL MOUNT

1. Remove the knockouts from the conduit plate. Use the plate as a
template. Mark the conduit and fastener positions onto the mounting
surface. Prepare the surface.

2. Attach the gasket to the end of the EWM.

3. Install the conduit fittings (not supplied). If conduit is not used, install

sealing glands (supplied) on the conduit plate. Thread the wiring/cabling

through the conduit plate/sealing glands and EWM wall mount. Attach
the EWM to the mounting surface with the appropriate hardware (not
supplied). Refer to the manual supplied with the Esprit system to
complete the installation.

NOTE: Refer to Tables A and B for wiring distances.

EPM ESPRIT POLE MOUNT

1. Thread wiring/cabling through the hole in the pole mount and attach the
mount to the pole with three stainless steel straps (supplied).

2. Attach the gasket to the end of the EWM.

3. Remove the knockouts from the conduit plate. Install the conduit fittings
(not supplied). If conduit is not used, install sealing glands (supplied) on
the conduit plate. Route the wiring/cabling through the conduit plate/
sealing glands and EWM wall mount. Secure the EWM and conduit
plate to the pole mount with the supplied hardware. Refer to the manual
supplied with the Esprit system to complete the installation.

ECM100 ESPRIT CORNER MOUNT

1. Use the ECM100 mount as a template and mark the fastener positions
onto the mounting surface. Prepare the surface. Route the wiring/
cabling through the ECM100. Attach the ECM100 to the mounting
surface with the appropriate hardware (not supplied).

2. Attach the gasket to the end of the EWM.

3. Remove the knockouts from the conduit plate. Install the conduit fittings
(not supplied). If conduit is not used, install sealing glands (supplied) on
the conduit plate. Route the wiring/cabling through the conduit plate/
sealing glands and EWM wall mount. Secure the mount to the ECM100
with the supplied hardware. Refer to the manual supplied with the
Esprit system to completed the installation.

NOTE: Refer to Tables A and B for wiring distances.

NOTE: Refer to Tables A and B for wiring distances.