Pelco ENC5400-4PORT User Manual

Digital Sentry® ENC5400 Capture Card

ENC5400-2PORT or ENC5400-4PORT

Installing an ENC5400 2-Port or 4-Port Capture Card

PREPARING AND INSTALLING THE 2-PORT CAPTURE CARD

1. Unscrew and remove the metal filler bracket for the PCIe x 4 slot. Set
aside the screw.

2. Replace the high-profile bracket with the low-profile bracket
(supplied) as follows.

a. Remove the two screws that secure the high-profile bracket to

the card. Set aside the screws.

b. Align the screw holes on the card and the low-profile bracket.

c. Insert and tighten the two screws.

3. Align the card with the PCIe x 4 slot.

4. Gently press down on the card so that it is properly seated in the
PCIe x 4 slot.

5. Insert and tighten the metal bracket screw to secure the card.

INSTALLATION

C5614M (10/11)

Completing the 2-Port Capture Card Installation

1. Carefully place the chassis cover on the unit.

2. Make sure the chassis and chassis cover screw holes are aligned.

3. Use a Phillips screwdriver to secure the chassis cover to the chassis
(two screws on the top front, two screws on the left and right side,
and three screws on the rear).

4. Close and lock the bezel.

Figure 1. Removing the Filler Bracket: 2-Port Capture Card

Figure 2. Installing the 2-Port Capture Card

PREPARING AND INSTALLING THE 4-PORT CAPTURE CARD

1. Unscrew and remove the metal filler brackets for slot 3 and slot 4
(PCIe x 4). Set aside the screws.

2. Replace the high-profile bracket with the low-profile bracket
(supplied) for both the primary and the secondary cards:

a. Remove the two screws that secure the high-profile bracket to

the card. Set aside the screws.

b. Align the screw holes on the card and the low-profile bracket.

c. Insert and tighten the two screws.

3. Connect the primary card and the secondary card with the 20P flat
cable (supplied).

4. Align the primary card with the PCIe x 4 slot.

5. Gently press down on the card so that it is properly seated in the
PCIe x 4 slot.

6. Insert and tighten the metal bracket screw to secure the primary card.

7. Align the secondary card in the third slot (next to the PCIe x 4 slot).

8. Gently press down on the card so that it is properly seated.

9. Insert and tighten the metal bracket screw to secure the secondary
card.

Figure 3. Removing the Filler Brackets: 4-Port Capture Card

Completing the 4-Port Capture Card Installation

1. Carefully place the chassis cover on the unit.

2. Make sure the chassis and chassis cover screw holes are aligned.

3. Use a Phillips screwdriver to secure the chassis cover to the chassis
(two screws on the top front, two screws on the left and right side,
and three screws on the rear).

4. Close and lock the bezel.

Figure 4. Installing the 4-Port Capture Card