Pelco c294m User Manual

= Vertical bar in the right margin indicates change or addition.

SWM-PA Series

Pole Adapter for the

®

Spectra

Compact

Wall Mount

Installation/Operation Manual

1.0 WARNINGS

2.0 DESCRIPTION

C294M (11/98)

1. Installation and servicing should only be done by qualified service personnel
and conform to all local codes.

2. Installation shall be done in accordance with all local and national electrical
and mechanical codes utilizing only approved materials.

Please thoroughly familiarize yourself with the information in this

manual prior to installation and operation.

The SWM-P A Series P ole Adapter is designed to adapt P elco’s SWM Series Spec­tra® Compact Wall Mount to a pole. It can be used for either indoor or outdoor
applications. The adapter is supplied with two stainless steel straps and two stain­less steel screws. The adapter is attached to a pole with the two straps, and a
mounting cleat (supplied with the wall mount) is installed on the adapter with the
two stainless steel screws. Once the mounting cleat is firmly in position on the
adapter, the SWM wall mount is then attached and held in place by a set screw.
The adapter and mounting cleat both have a feedthrough opening for electrical
cables, not a conduit fitting.

The adapter is constructed of aluminum and has either a light gray or black polyes­ter powder coat finish.

2.1 MODELS

SWM-PA-GY Pole adapter for use with the SWM Series Spectra® Compact

Wall Mount. Gray finish.

SWM-PA-BK Same as SWM-GY, except black finish.

Pelco • 3500 Pelco Way, Clovis, CA 93612-5699 • USA • www.pelco.com
In North America and Canada: Tel [phone] • FAX [phone]

International Customers: Tel [phone] or FAX [phone]

3.0 INSTALLATION

3.1 SWM-PA SERIES
POLE ADAPTER

To attach the SWM-P A Series pole adapter, perf orm the following steps (see Figure
1 and Table A):

1. Determine the location on the pole where the adapter is to be installed.

2. Position the adapter on the pole so the embossed orientation arrow points
upward. Feed the electrical cables through the cable hole, and attach the
adapter to the pole with two stainless steel straps (supplied).

3. After attaching the pole adapter to a pole, apply Duct Seal to the hole and
around the electrical cable. This will pre v ent moisture from entering the mount
and causing condensation which could damage the equipment. Duct Seal can
be purchased through local electrical supply houses.

4

5

2

1

6

3

Figure 1. SWM-PA Pole Adapter Locator Drawing

Table A. SWM-PA Pole Adapter Key List

Item Qty Description

11Pole adapter, gray or black
21Mounting cleat (not supplied)
32Stainless steel strap
42Screw, 1/4-20, socket head
51Spectra® Compact Wall Mount (not supplied)
61Set screw, 10-24 (not supplied)

2 Pelco Manual C294M (11/98)