Pelco C2946M User Manual

C2947M-E (6/09)
C10CH Series Camera
Quick Start Guide

This quick start guide describes how to install and configure the C10CH Series camera in most
applications. It contains a representation of the setup menus to help you locate and change specific
settings.

Refer to the enclosed CD for the following documentation:

• Installation/Operation manual: C2946M

• Quick Start Guide: C2947M

• Important Safety Instructions: SAFETY.PDF

MODELS

C10CH-6 1/3-inch ultra high resolution color, CCD camera, 24 VAC or 12 VDC, NTSC format

C10CH-6X 1/3-inch ultra high resolution color, CCD camera, 24 VAC or 12 VDC, PAL format

C10CH-7X 1/3-inch ultra high resolution color, CCD camera, 220 to 240 VAC, PAL format

C10CH-7X BACK

ì Camera Mount

î Back Focus Locking Screw

ï Lens Mount

ñ Auto Iris Lens Connector

ó Setup Button

r Ground Screw

s Power Connector

• C10CH-6/6X, Power Terminal Block

• C10CH-7X, Power Cord

t Video Output Connector

SETUP MENUS

The camera default settings are set at the factory to operate in most applications and lighting co nditions,
and normally require no adjustments. Sometimes, however, adjustments may be necessary.

Use the setup menus to customize the camera settings for your application as needed. Refer to the
Installation/Operation manual (C2946M) for complete instructions and explanations of camera settings.

PROFILES

STANDARD
GAMING
CUSTOM

MAIN MENU

PROFILES
EXPOSURE SET.
FUNCTION SET.
SAVE AS CUSTOM
PIXEL CORRECTION
SYSTEM INFORMATION

->

->

->

->

->

->

EXIT

BACK EXIT

AUTO EXPOSURE
ECLIPSER
DC IRIS LEVEL
FLICKERLESS
AGC

BACK EXIT

EXPOSURE SET.

-> ESC

-> OFF

-> -4

-> OFF

-> LOW

ECLIPSER
THRESHOLD
LEVEL

BACK EXIT

ECLIPSER

-> OFF

-> 17

-> 4

FUNCTION SET.

LINE SYNC
WHITE BALANCE
CHROMA
GAMMA
SHARPNESS
CABLE COMPENSATION
MASKING
TITLE

BACK EXIT

SAVE AS CUSTOM

CURRENT SETTING
ARE SAVED

OK CANCEL

PIXEL CORRECTION

COVER THE LENS
AND PRESS OK

OK CANCEL

SYSTEM INFORMATION

FIRMWARE VERSION
OSD VERSION

RESTORE FACTORY SETTINGS

RETURN END

-> AUTO

-> AUTO

->

-> 60%

-> SHARP

-> SHORT

->

->

->

LINE SYNC

LINE SYNC
V-PHASE ADJ

BACK EXIT

-> AUTO

-> 38

MASKING

MASK
MASK COLOR
MASK EDIT
MASK ERASE

BACK EXIT

-> OFF

-> -2

-> 0

TITLE

EDIT TITLE

BACK EXIT

-> OFFTITLE

RESTORE FACTORY SETTING

#.##
#.##

ALL SETTING ARE
INITIALIZED

OK CANCEL