Pelco C2907M-QS User Manual
™
NET350
MULTIMEDIA TRANSMISSION VIA NETWORK
QUICK START
®
GUIDE
C2907M-QS (09/03)
BEFORE YOU BEGIN
Installation of PelcoNet NET350 requires support from your network
administrator. Contact your administrator to assist with STEP 2A –
Configuring PelcoNet Using HyperTerminal. Write down the following
information from your network administrator:
1. A unique IP address for each NET350 unit
____.____.____.____. ____.____.____.____.
2. The subnet mask for each IP address
____.____.____.____. ____.____.____.____.
3. The default gateway for each address
____.____.____.____. ____.____.____.____.
2
STEP 1A
CONNECTING THE TRANSMITTER —
NET350T
1. Plug in the supplied power adapter to power-up the PelcoNet. Be sure
to use the correct power supply adapter (configure if needed).
2. Attach a camera to the Video In connector.
3. Connect a network cable to the Ethernet port.
4. (Optional) Connect the COM1: RS232/422/485 port with a serial cable
to any controllable devices (for example, Genex® multiplexer, System
9760®, Spectra® dome).
NET350 FRONT
Ethernet Power
Compact Flash
Alarm I/O
LTOI
Video In
NET350 BACK
75
Audio I/O
COM2:
RS232
COM1:
RS232/422/485
4800, 8, NONE, 1
3
Power
TX+
TX-
RX+RX-
RECEIVER OR SPECTRA
STEP 1B
CONNECTING THE RECEIVER —
NET350R
NOTE: Skip this step if a receiver will not be used.
1. Plug in the supplied power adapter to power-up the PelcoNet. Be sure
to use the correct power supply adapter (configure if needed).
2. Attach a monitor to the Video Out connector.
3. Connect a network cable to the Ethernet port.
4. (Optional) Connect the COM1: RS232/422/485 port with a serial cable
to a keyboard (for example, KBD4000, CM9760-KBD, KBD300A).
NET350 FRONT
Ethernet Power
Alarm I/O
LTOI
Video Out
MONITOR
NET350 BACK
75
Audio I/O
COM2:
RS232
COM1:
RS232/422/485
4800, 8, NONE, 1
Power
RX-
RX+
12 VAC
4
3
2
1
4
5
DIRECT
6
MODE
7
8
STRAIGHT
CABLE
KBD300A
STEP 2A
CONFIGURING THE NET350 USING
HYPERTERMINAL
NOTE: If you do not want to configure PelcoNet using HyperTerminal or NETManager, refer to the PelcoNet NET350 manual for instructions on configuring
PelcoNet using a web browser.
1. Connect a null modem RS232 serial cable from your computer’s COM
port to the COM2: RS232 port on the NET350’s back panel.
75
Video In
2. Click the Start button on the desktop, and then select Programs from
the Start menu.
3. Highlight Accessories. Highlight Communications. Click
HyperTerminal.
Audio I/O
COM2:
RS232
COM1:
RS232/422/485
Power
5
Loading...