Pelco c2235m User Manual
C2235M (4/07)
PMCL-V100
Monitor Mount Adapter
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Installation should be done only by qualified personnel and conform to all local codes.
6. Use only installation methods and materials capable of supporting four times the maximum specified load.
7. Only use replacement parts recommended by Pelco.
8. This unit is designed for indoor use only, and it must not be installed where exposed to rain or moisture.
Description
The PMCL-V100 monitor mount adapter allows an LCD monitor mount to be used with Pelco’s PMCL526 LCD monitor. The PMCL-V100 monitor mount
adapter can be used with the following Pelco mounts:
PMCL-WMT Tilt-swivel wall mount
PMCL-WM1A Single-arm wall mount
PMCL-WM2A Double-arm wall mount
PMCL-CM Ceiling mount
PMCL-CMP Ceiling mount and telescoping pole
Installation
The following parts are supplied:
Qty Description
1 Adapter plate
4 10-32 x 3/4-inch pan head Phillips screws, stainless steel
4 #10 split lock washers
4 10-32 hex nuts, stainless steel
6 M4 x 0.70 x 6 mm pan head Phillips screws, stainless steel
To attach the PMCL-V100 to a monitor mount:
1. Use the 10-32 x 3/4-inch pan head Phillips screws, #10 split lock washers, and hex nuts (supplied) to secure the adapter plate to the monitor mount.
Refer to Figure 1.
HEX NUTADAPTER PLATE
#10 SPLIT LOCK WASHER
PMCL-WM1A MONITOR MOUNT
10-32X3/4 PHILLIPS SCREW
Figure 1. Attaching the PMCL-V100 Monitor Mount Adapter to a Monitor Mount
2. Attach the monitor mount to the monitor. Align the monitor to the correct hole pattern on the mounting plate. Use the M4 x 0.70 x 6 mm screws
(supplied) to secure the monitor to the mounting plate. Refer to Figure 2.
PMCL-V100 ADAPTER PLATEPMCL-WM1A MONITOR MOUNT
M4X10MM PHILLIPS SCREW
Figure 2. Attaching the PMCL-V100 Adapter and Monitor Mount to a Monitor
3. Refer to the installation manual shipped with the Pelco monitor mount for further instructions.
Loading...