Pelco C2219M User Manual

C2219M (11/05) PMCL-WM Monitor Mount

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings

4. Follow all instructions.

5. Only use attachments/accessories speciﬁed by the manufacturer.

6. Use only with a cart, stand, tripod, bracket, or table speciﬁed by the manufacturer, or sold with the apparatus.When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

7. Installation should be done only by qualiﬁed personnel and conform to all local codes.

8. Use only installation methods and materials capable of supporting four times the maximum speciﬁed load.

9. Only use replacement parts recommended by Pelco.

The product and/or manual may bear the following marks:

This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.

This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.

Description

The PMCL-WM monitor mount is designed for attaching PMCL Series ﬂat panel, TFT LCD monitors to a wall.

Installation

The following parts are supplied:

QTY DESCRIPTION

1 Monitor bracket 1 Wall bracket 1 10-32 socket head screw 4 M4 x 10 mm screws 4 Split lock washers

CAUTION:

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

To install the wall mount:

1. Attach the monitor bracket to the monitor as shown in Figure 1. Use the M4 x 10 mm screws and split lock washers.

2. Attach the wall bracket to the wall with the short side pointing down. Hardware is not supplied. Use hardware capable of supporting 68 pounds (30.8 kg). Refer to the following chart for recommended installation surfaces and minimal hardware requirements.

Recommended Mounting Surface Recommended Hardware

Solid Concrete* Four 1/4 x 2 3/4-inch strike anchors

Hollow cinder block Four 1/4 x 2 1/2-inch T-anchors

Wall board/2 x 4’s

Two 1/4 x 2-inch lag bolts (bolts must be attached to stud) and two 1/4 x 2-inch anchor bolts

Plywood (3/4-inch construction grade) Four 1/4 x 2-inch lag bolts

*Recommended strength of concrete is 3600 psi or 25 Mpa.

(4) LOCK WASHERS

(4) SCREWS, M4 X 10 MM

Figure 1. Attaching Monitor Bracket

+ 2 hidden pages