Pelco c1978m User Manual

®

NET101RK

19-Inch PelcoNet

™

Rack Mount Kit

Installation/

Operation Manual

C1978M (11/01)

Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.com

In North America and Canada: Tel [phone] • FAX [phone]

International Customers: Tel [phone] • FAX [phone]

IMPORTANT SAFEGUARDS AND WARNINGS

Prior to installation and use of this product, the following WARNINGS should be observed.

1. Installation and servicing should only be done by qualified service personnel and con­form to all local codes.

2. Only use replacement parts recommended by Pelco.

3. After replacement/repair of this unit’s electrical components, conduct a resistance
measurement between line and exposed parts to verify the exposed parts have not
been connected to line circuitry.

The product and/or manual may bear the following marks:

This symbol indicates that dangerous volt­age constituting a risk of electric shock is
present within this unit.

This symbol indicates that there are impor­tant operating and maintenance instructions
in the literature accompanying this unit.

Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.

REGULATORY NOTICES

This equipment has been tested and found to comply with the limits of a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide rea­sonable protection against harmful interference in a residential installation. This equip­ment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio com­munications. However there is no guarantee that the interference will not occur in a par­ticular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is en­couraged to try and correct the interference by one or more of the following measures:

CAUTION:

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the re­ceiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

2 Pelco Manual C1978M (11/01)