Pelco c1964m-b User Manual

C1964M-B (6/02)
VIDEO4X4
Video Security System

®

3500 Pelco Way
Clovis, CA 93612-5699
USA

In North America & Canada:
Tel [phone]
FAX [phone]

International Customers:
Tel [phone]
FAX [phone]

www.pelco.com

IMPORTANT

Only use the installation methods illustrated in this manual to properly install the
VIDEO4X4 or VIDEO4X4PLUS system. Do not refer to the installation methods illus­trated in the manuals supplied with the components (DVR, monitor, and cameras).
Refer to component manuals for operating instructions only.

DESCRIPTION

Pelco’s VIDEO4X4 is an all-in-one video security system. The system includes a digital video
recorder, quad monitor, and four cameras with mounts.

Models

VIDEO4X4 Four-channel digital video recorder, 30 GB hard drive for video storage,

120 VAC, NTSC

VIDEO4X4PLUS Four-channel digital video recorder, 60 GB hard drive for video storage,

120 VAC, NTSC

INSTALLATION

There are two methods of installation for the system; full screen playback and quad view play­back. Refer to Figures 1 and 2. Select the desired configuration for your installation. Make all
equipment connections as illustrated in the drawing.

Pelco Manual C1964M-B (6/02) 1

FULL-SCREEN PLAYBACK

4

Images Per Second: With preview – up to 2 fps

Without preview – up to 3 fps

Record Time: 2 weeks (1 fps) with 30 GB hard drive

4 weeks (1 fps) with 60 GB hard drive

Playback Mode: Individual camera, full-screen

To setup the VIDEO4X4 for full-screen playback refer to Figure 1 and do the following:

1. Connect the cameras to the S-Video inputs located on the back of the monitor. An S-video
cable is supplied with each camera. Set all switches to HI. Set the monitor output switch to
75Ω.

2. Use a BNC cable (supplied) and connect CH1 OUT from the monitor to the CAMERA 1
INPUT of the recorder. Repeat step for all other cameras (CH2 OUT to CAMERA 2 INPUT).

3. Connect the recorder’s MONITOR OUTPUT to the VIDEO IN located on the back of the
monitor. Use the supplied BNC/RCA adapter to connect the BNC cable to VIDEO IN.

4. Program the VIDEO4X4 system:

a. Set the monitor to VCR mode.

b. Program the DX1004 recorder:

(1.) Set Camera operation for all cameras to ON. If a camera is not used set Camera

operation to OFF.

(2.) Set the Preview Function.

(3.) Select the resolution for all cameras.

(4.) Program fps for all cameras.

NOTE:

Set all monitor termina­tion switches to HI impedance.
Set the monitor output switch to
75Ω.

Refer to the manuals supplied with the monitor and recorder for programming instructions.

75 Hi 75 Hi 75 Hi 75 Hi 75 Hi

IN

CH 1 CH 3 CH 4CH 2

IN/OUT

CH 1 CH 2 CH 3 CH 4 TRIG

OUTPUT

MONITOR

VIDEO PRINTER

ALARM SENSOR

OUT

REMOTE

ON OFF

NTSC

PAL

OUT

I

NMO TOR

POWER

VIDEO AUDIO

*

AC IN

MONITOR

FOCUS

SCREEN

RECORDER

MAIN

A/C INLET

INPUT

CAMERA

1 1 2 2 3 3 4

VIDEO IN

IN

OUT

00945

Figure 1. Full-Screen Playback

2 Pelco Manual C1964M-B (6/02)