Pelco C1656M-A, NVR5000PS User Manual
C1656M-A (2/06)
Endura
™
NVR5000PS
Replacement Power Supply
This document describes how to replace a failed power supply in any of the following:
• NVR5100 Series network video recorder
• SEB5100 Series storage expansion box
• DVR5300 Series digital video recorder
NOTES:
• You can replace one failed power supply without shutting down the unit.
• No tools are required to replace this component.
• The NVR5100 rear panel is shown in this document. The power supplies are in the same locations in the SEB5100 and the DVR5300.
Replacing the Power Supply
1. Review all instructions in this document before proceeding.
2. Identify the failed power supply. The status indicator will be red or dark.
3. Unplug the power cord from the failed power supply as follows:
WARNING: For safety, you must unplug the power cord from the wall socket or other power source before unplugging it from the failed power
supply on the unit.
a. Unplug the power cord for the failed power supply from the power source.
b. Unplug the power cord from the failed power supply at the rear panel of the unit.
4. Using your thumb, lift the power supply latch while holding the pull handle.
PULL HANDLE
POWER
SUPPLY
LATCH
POWER
SUPPLY
STATUS
INDICATOR
Model
t
x
e
SA
U
N
le T
I
E
V
mp
a
E
AD
S
R
M
A
C
,
S
I
V
xt
LO
C
S
,
T
le Te
L
CO
O
mp
V
a
EL
S
P
Y
B
G
F
M
03267-39-0020
s
xt
u
t
e
a
r
T
a
S
p
le
P
p
p
A
K
M
m
A
o
a
1K
e
9
S
d
Vi
/
o
i
d
Z
u
Q
L
A
0H
E
6
DE
/
R
SN
0
O
F
5
M
Figure 1. Releasing the Power Supply Latching Mechanism
5. Gently pull the failed power supply completely out of the unit.
Figure 2. Removing the Power Supply
6. Orient the replacement power supply so that the cord receptacle is at the bottom of the unit.
CORD RECEPTACLE
Figure 3. Aligning the Power Supply
7. Gently push the replacement power supply into the unit until it locks into place.
8. Connect the power cord for the replacement power supply as follows:
WARNING: For safety, you must plug the power cord into the power supply before plugging it into the wall socket or other power source.
a. Plug the power cord into the receptacle on the replacement power supply.
b. Plug the power cord into the power source.
9. Verify that the green indicator is lit on the newly installed power supply. Also, the power supply alarm will stop.
Loading...