Pelco 207, 207W User Manual

Release Notes

Axis IP Cameras Supported on Digital Sentry

Integral Digital Sentry® digital video management systems (DVMS) support certain
Axis® IP camera models. The camera models listed in this document can be used with
Digital Sentry IP camera driver 6.8.0.126 and later. Refer to each camera’s
table for information about the hardware and software features validated for use on a
Digital Sentry system. Any general limitations or special instructions are listed at the
beginning of the document, and any model-specific information is listed after each table.
For information about the general usage of each camera, refer to the camera
manufacturer’s documentation.

A single AXIS driver in DSAdmin controls all supported AXIS cameras.

To obtain the latest IP camera driver or documentation for use with Digital Sentry, refer
to the Pelco Web site at

AXIS 206, AXIS 207, AXIS 207W

www.pelco.com

.

Firmware N/A

Supported Resolutions 640 x 480 maximum

Frames per Second (FPS) 1 to 30

Number of Quality Settings 10

Supported Codec MJPEG

Supported Motion Detection Integral, In-Camera

Pan/Tilt/Zoom (PTZ) Not available

C1002RN (1/09) Page 1 of 4

AXIS 207MW

Firmware N/A

Supported Resolutions 1280 x 1024 maximum

FPS 1 to 14

Number of Quality Settings 10

Supported Codec MJPEG, MPEG-4

Supported Motion Detection Integral, In-Camera

PTZ Not available

AXIS 210, AXIS 210A, AXIS 211, AXIS 211A, AXIS 221

Firmware N/A

Supported Resolutions 640 x 480 maximum

FPS 1 to 30

Number of Quality Settings 10

Supported Codec MJPEG, MPEG-4

Supported Motion Detection Integral, In-Camera

PTZ Not available

AXIS 212 PTZ

Firmware N/A

Supported Resolutions 640 x 480 maximum

FPS 1 to 30

Number of Quality Settings 10

Supported Codec MJPEG, MPEG-4

Supported Motion Detection Integral, In-Camera

PTZ Yes (solid state)

Page 2 of 4 C1002RN (1/09)