®
Installation/Operation
Camclosure® Lens Packs
C1971M-D (1/03)
Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.com
In North America and Canada: Tel (800) 289-9100 or FAX (800) 289-9150
International Customers: Tel +1 (559) 292-1981 or FAX +1 (559) 348-1120
DESCRIPTION
The lens packs for Pelco’s ICS090, ICS100, ICS150, ICS200, and ICS300 Series Camclosure® integrated camera systems contain an interchangeable lens mount(s) and lens(es). All lenses are fixed focal length, ranging from 2.9 mm to 12 mm.
NOTE: Do not replace varifocal lenses. Only Camclosure integrated camera systems with fixed focal length lenses have an interchangeable lens mount and lens. If your unit has a varifocal lens, do not remove the mount or lens.
Models
13FF3D |
One 2.9 mm lens and mount |
13FF3.6D |
One 3.6 mm lens and mount |
13FF6D |
One 6 mm lens and mount |
13FF8D |
One 8 mm lens and mount |
13FF12D |
One 12 mm lens and mount |
13FF3D-4PAK |
Package of four 2.9 mm lenses and mounts |
13FF3.6D-4PAK |
Package of four 3.6 mm lenses and mounts |
13FF6D-4PAK |
Package of four 6 mm lenses and mounts |
13FF8D-4PAK |
Package of four 8 mm lenses and mounts |
13FF12D-4PAK |
Package of four 12 mm lenses and mounts |
13FFD-V5PAK |
Variety package of five lenses, one each 2.9 mm, 3.6 mm, 6 mm, 8 mm, 12 mm, and |
|
mounts |
INSTALLATION
Remove the camera module from the base of the enclosure. After replacing and adjusting the lens, reinstall the camera module.
Monochrome Camera
The lens mount installed on the monochrome camera is fixed; the following:
1. Remove the lens from the camera mount.
DO NOT REMOVE. To replace the lens do
LOOSEN SET
SCREW. DO
NOT REMOVE.
a.Loosen the set screw located on the lens mount. Back out the set screw until it clears the threads of the lens. Do not completely remove set screw.
REMOVE LENS
b. Unscrew the lens by turning it counterclockwise.
TURN COUNTERCLOCKWISE
2.Mount the replacement lens by carefully threading it clockwise onto the lens mount.
3.Remove the dust cover from the lens.
4.Lens Adjustment – Turn the lens clockwise/ counterclockwise until the picture on the monitor is in focus. Carefully tighten the set screw. Do not over-tighten.
DO NOT OVER-
TIGHTEN SET
SCREW
MOUNT AND
ADJUST LENS
TURN CLOCKWISE
[ 2 ] Pelco Manual C1971M-D (1/03)