IMPORTANT SAFETY INSTRUCTIONS
Notice to Installers
The servicing instructions in this notice are for use by quali ed
service personnel only. To reduce the risk of electric shock, do not
perform any servicing other than that contained in the operating
instructions, unless you are quali ed to do so.
Note to System Installer
For this apparatus, the coaxial cable shield/screen
shall be grounded as close as practical to the point of
entry of the cable into the building.For products sold in
the US and Canada, this reminder is provided to call the
system installer's attention to Article 820-93 and Article
820-100 of the NEC (or Canadian Electrical Code Part
1), which provides guidelines for proper grounding of
the coaxial cable shield.
This symbol is intended to alert you that uninsulated
voltage within this product may have sufficient
magnitude to cause electric shock.Therefore, it is
dangerous to make any kind of contact with any inside
part of this product.
Ce symbole a pour but d’alerter toute personne qu’un
contact avec une pièce interne de ce produit, sous
tension et non isolée, pourrait être suffisant pour
provoquer un choc électrique. Il est donc dangereux
d’être en contact avec toute pièce interne de ce produit.
CAUTION: To reduce the risk of electric shock, do not remove
cover (or back). No user-serviceable parts inside. Refer servicing
to qualified service personnel.
This symbol is intended to alert you of the presence of important
operating and maintenance (servicing) instructions in the literature
accompanying this product.
Ce symbole a pour but de vous avertir qu’une documentation
importante sur le fonctionnement et l’entretien accompagne ce
produit.
WARNING
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding-type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
12) Use only with the cart, stand, tripod, bracket,
13) Unplug this apparatus during lightning storms or when
14) Refer all servicing to qualified service personnel.
or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination
to avoid injury from tip-over.
unused for long periods of time.
Servicing is required when the apparatus has been
damaged in any way, such as a power-supply cord
or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
Power Source Warning
A label on this product indicates the correct power source for this
product. Operate this product only from an electrical outlet with
the voltage and frequency indicated on the product label. If you are
uncertain of the type of power supply to your home or business,
consult your service provider or your local power company.
The AC inlet on the unit must remain accessible and operable at
all times.
Ground the Product
product connects to coaxial cable wiring, be sure the cable
system is grounded (earthed). Grounding provides some
protection against voltage surges and built-up static charges.
Do not locate an outside antenna system in the vicinity of
overhead power lines or power circuits. Touching power
lines or circuits might be fatal.
This product may contain a tuner capable of receiving o -the-air
broadcasts.
Protect the Product from Lightning
In addition to disconnecting the AC power from the wall outlet,
disconnect the signal inputs.
Verify the Power Source from the On/O Power Light
When the on/o power light is not illuminated, the apparatus may
still be connected to the power source. The light may go out when
the apparatus is turned o , regardless of whether it is still plugged
into an AC power source.
Eliminate AC Power/Mains Overloads
not overload AC power/mains, outlets, extension cords,
or integral convenience receptacles. For products that
require battery power or other power sources to operate
them, refer to the operating instructions for those products.
Provide Ventilation and Select a Location
• Remove all packaging material before applying power to the product.
• Do not place this apparatus on a bed, sofa, rug, or similar surface.
• Do not place this apparatus on an unstable surface.
• Do not install this apparatus in an enclosure, such as a bookcase
or rack, unless the installation provides proper ventilation.
• Do not place entertainment devices (such as VCRs or DVDs), lamps,
books, vases with liquids, or other objects on top of this product.
• Do not block ventilation openings.
Operating Environment
This product is designed for operation indoors with a temperature
range from 32° to 104° F (0° to 40°C). Each product should have
adequate spacing on all sides so that the cooling air vents on the
chassis are not blocked.
Protect from Exposure to Moisture and Foreign
Objects
not expose this product to dripping or splashing liquids,
rain, or moisture. Objects lled with liquids, such as vases,
should not be placed on this apparatus.
Unplug this product before cleaning. Do not use a liquid
cleaner or an aerosol cleaner. Do not use a magnetic/static
cleaning device (dust remover) to clean this product.
Never push objects through the openings in this product.
Foreign objects can cause electrical shorts that can result
in electric shock or re.
WARNING: Avoid electric shock and re hazard! If this
WARNING: Avoid electric shock and re hazard!
WARNING: Avoid electric shock and re hazard! Do
WARNING: Avoid electric shock and re hazard! Do
WARNING: Avoid electric shock and re hazard!
WARNING: Avoid electric shock and re hazard!