Manual
Unihan AWM6018-P
Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject to the follow in g
i.
This device may not cause harmful interference, and
ii.
This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
i.
Reorient or relocate the receiving antenna.
ii.
Increase the separation between the equipment and receiver.
iii.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
iv.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION! You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC: Office of the
Federal Register, National Archives and Records Administration, U.S. Government Printing Office.
Safety statements
Regulatory Information/Disclaimers
Installation and use of this Bluetooth device must be in strict accordance with the instructions included
in the user documentation provided with the product. Any changes or modifications (including the
antennas) made to this device that are not expressl y approved by the manufacturer may void the user’s
authority to operate the equipment. The manufacturer is not responsible for any radio or television
interference caused by unauthorized modification of this device, or the substitution of the connecting
cables and equipment other than manufacturer specified. It is the responsibility of the user to correct
any interference caused by such unauthorized modification, substitution or attachment. Manufacturer
and its authorized resellers or distributors will assume no liability for any damage or violation of
government regulations arising from failing to comply with these guidelines.
CAUTION! To maintain compliance with FCC’s RF exposure guidelines, this equipment should be
installed and operated with minimum distance [20cm] between the radiator and your body. Use on the
supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter
and may violate FCC regulations.
Safety Information
In order to maintain compliance with the FCC RF exposure guidelines, this equipment should be
installed and operated with minimum distance [20cm] between the radiator and your body. Use only
with supplied antenna.
Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC
regulations.
CAUTION! Any changes or modifications not expressly approved in this manual could void your
authorization to use this device.
MPE Statement
Your device contains a low power transmitter. When device is transmitted i t sends out Radio Frequency
(RF) signal.
FCC Radio Frequency Exposure
This Bluetooth device has been evaluated under FCC Bulletin OET 65C and found compliant to the
requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247(b)(4) addressing RF Exposure
from radio frequency devices. The radiation output po wer of this Bluetooth device is far below the FCC
radio frequency exposure limits. Nevertheless, th is device shall be used in such a manner that the
potential for human contact during normal operation – as a mobile or portable device but use in a
body-worn way is strictly prohibit. When usin g this device, a certain separation distance between
antenna and nearby persons has to be kept to ensure RF exposure compliance. In order to comply with
the RF exposure limits established in the ANSI C95.1 standards, the distance between the antennas and
the user should not be less than [20cm].
RF Exposure
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
About this guide
This user guide contains the information your PEGATRON WIFI Module.
System requirements
Before installing the PEGATRON WIFI module, make sure that your system meets the
following requirements:
z
Intel® Pentium® 4 or AMD K7/K8 system
z
Minimum 64MB system memory
z
Windows® XP/VISTA operating system
z
An available USB port (USB 2.0 recommended because USB 1.1 cannot achieve
maximum wireless performance)
Installing the device drivers
To install the device driver in your computer:
Insert the support CD to the optical drive and follow the following procedure.
Step 1
Step 2
Step 3
Step 4
Loading...