Peerless Lighting SPM9 User Manual

Type: ________________________

Staple Lens I/D

Indirect-Direct T5/T5HO

SPECIFICATIONS

________ ________ ________ ________ ________ ________ ________ ________ ________ ________ ________ ________ ________ ________ ________ ________ ________ _____________________

Suspended SPM9

Project: ______________________

LAMPING OPTIONS

SPM9 - 1 SPM9 - 2 SPM9 - 3

2 3⁄8” 2 3⁄8” 2 3⁄8”

8 1⁄2” 8 1⁄2” 8 1⁄2”

SPECIFICATIONS

Construction

Nominal 8 1⁄2” x 2 3⁄8” rectangular housing is
formed from cold-rolled steel. Die-cast aluminum
end caps are mechanically attached with no
exposed fasteners.

Reflectors/Shielding

Formed, pre-finished white reflector standard.
Acrylic lens shielding.

Finish

White gloss powder paint comes standard. Custom
colors available, consult factory.

Electrical

Specify 120V, 277V or 347V. Pre-wired with 16AWG
fixture wires. For special circuiting or wire gauge,
consult factory. Plug-in electrical connectors
included. UL and C-UL listed.

Luminaire Length

4’, 8’ and 12’ lengths in a single section for nominal
suspension spacing of 4’, 8’ and 12’. For total
luminaire length, add 1 1⁄8” for each end cap. Using
internal joiners, 4’, 8’ and 12’ sections can be joined
to form longer length luminaires.

Installation Features

Y-hangers with adjustable cables come standard
to simplify luminaire leveling across the width
and length. Individual 4’, 8’ and 12’ luminaires
can be ordered with end caps and power cords
pre-installed and hanging hardware included in the
luminaire packaging to reduce overall installation
time (option IND).

Packaging

Recycled cardboard box, folded cardboard cradles
and kraft tape. Biodegradable protective luminaire bag.

CATALOG NUMBER

Examples: SPM9 2 54T5HO WHR 40FT R12 277 GEB10 DCT LP835 F1/24 C032  — SPM9 1 54T5HO WHR 32FT R8 120 GEB10 1SE EL SCT LP835 F1/24 C032

__________ __________ __________ __________ __________ _________ __________ __________ __________

Luminaire

SPM9

______________ ________________ ___________ ________________ ______________ ______________ ______________ _________________________________

# of
Emergency
Modules

(Blank) None
1SE 1 section
2SE 2 sections
XSE X sections

Notes:

1 Nominal distribution, refer to photometric test for exact distribution
2 Available with 3-lamp cross section only
3 Not available with 28T5 lamps
4 Not available in 347V

# of Lamps
in Cross
Section

1
2
3

Emergency Type

(Blank) None
EC Emergency

circuit

4

Emergency

EL

battery pack

4

Emergency

EN

battery pack
w/night light
circuit

Lamp Type

28T5 28W T5
54T5HO 54W T5HO

5

Switching

SCT Single

DCT

Distribution (nominal)

(Blank) 65% up, 35% down

standard

1

40% up, 60% down

40/60
20/801 20% up, 80% down
0/1001 100% down
CLI2 Center lamp isolator

Lamp Color

L/LP No lamp

circuit

Dual

LP830 3000k 80+ CRI
LP835 3500k 80+ CRI

circuit

LP841 4100k 80+ CRI

Available with T5 only:
LP830P

LP835P

LP841P

Reference Lamp Chart on
website or consult factory
for other options.

3000K 80+

3500K 80+

4100K 80+

5 EL and EC are installed in last 4’ of luminaire sections. Separate feed

6 Adjustable cable gripper comes standard

Reflector

WHR White

Reflector

Mounting Type /

F1/ T-bar ceiling

(universal mounting
bracket)

T-bar ceiling (UMB

F1A/

with integrated J-box)

Hard ceiling

F2/

CRI Premier

CRI Premier

CRI Premier

required unless ELS or ELS2 is specified

(horizontal J-box)

Luminaire
Row
Length

X FT

(4’ increments)

Maximum
Section
Length

R4 4’ section(s)
R8 8’ section(s)
R12 12’ section(s)

Overall
Suspension

24 24”

48”

48

72”

72

96”

96

XX”

XX

Overall suspension
is measured from
ceiling to bottom
of luminaire.

Finish

6

C032 White white

Custom finish

C099

Voltage

120
277

3

347

(high gloss)

Ballast Type

GEB10 <10% THD Electronic

3,4

ADEZ

Advance Mark 10 dim

DMHL3D3 Lutron Hi-Lume dim

3,4

OSDIM

Osram 0-10V dim

Reference Ballast Wizard on website
or consult factory for other options.

Options

CP Chicago plenum (available with F1A only)
DL Damp location label
DU Dust cover (not available with 3 T5HO)
ELH Emergency through wiring w/separate feed
ELS Emergency through wiring w/single feed,

shared neutral

Emergency through wiring w/single feed,

ELS2

separate neutrals

Fusing (fast blow)

GLR
GMF Fusing (slow blow)
IND Individual luminaire (factory installed

end caps and power cord, hanging
hardware in box)

Matching feed canopy at support

MCS
NEPP5D nLight enabled control module

per row/zone

New York City code

NYC
OJB Oset junction box
SLP Sloped ceiling (for 10-45°, must be

specified with F2 and OJB options)

Integrated sensor; choose options and

XXXX

obtain code on page 2

2246 5th Street, Berkeley, CA 94710 • Tel: [phone] • Fax: [phone] • Email: [e-mail] • PeerlessLighting.com

Products in this document may be covered by one or more U.S. Patents and Patents Pending. Specifications subject to change without notice.
1-year limited warranty. Complete warranty terms located at www.acuitybrands.com/customerresources/terms_and_conditions.aspx

© 2012 Acuity Brands Lighting, Inc. All Rights Reserved. “Peerless” is a registered trademark of Acuity Brands Lighting.

SPM9  Staple Lens I/D

Indirect-Direct T5/T5HO

1

1000

Type: ________________________

Staple Lens I/D

Project: ______________________

Indirect-Direct T5/T5HO

Suspended SPM9

INTEGRATED NLIGHT MICRO SENSOR

Determine the appropriate sensor type, network type and sensor power source for your application. Enter the code in the Options section of the Catalog Number.

EXAMPLE: PDT1

Sensor Type (choose one)

ADC

nLight model
nES ADCX

PDT

nLight model
nES PDT7 ADCX

For more information about the Integrated nLight Micro Sensor, its capabilities and options, download the PDF guide at: PeerlessLighting.com/nLight-Sensor-Guide
*nLight-Enabled (network-ready) options include one RJ-45 connector on the luminaire and 10’ of Cat-5e cable and a splitter to control the entire luminaire row (depending on
wattage/voltage limitations). The Cat-5e cable drop is located in the same section as the sensor. For multiple zones, please contact [e-mail].

Daylight Dimming

Specify 0-10V dimming ballast
No occupancy sensing

Daylight Dimming and/or Occupancy Detection

Specify 0-10v dimming ballast for daylight dimming
Specify fixed-output ballast for occupancy detection only
(daylight dimming disabled)

1* nLight-Enabled (Network-Ready) with Luminaire-Integrated Power Pack

10’ Cat-5e cable and splitter provided

2 Standalone Operation (No Networking) with Luminaire Integrated Power Pack

No Cat-5e cable provided

3* nLight-Enabled (Network-Ready) with Remote nLight Power Pack or nPanel

10’ Cat-5e cable and splitter provided
Order required remote nLight Power Pack or nPanel
separately through nLight (Acuity Brands Controls)

WEIGHTS & SUPPORT SPACING

Suspension spacing equals section length. Default location shown. Consult factory for stem mounting suspension spacing and alternate locations.

STANDARD SECTIONS

18 LBS

4’-2

4’-0”

1

⁄4” O.A.

1

1

⁄8” end caps

Network Type & Sensor Power Source (choose one)

Key:

Support/Support with CAT-5e

•

Sensor (if ordered)

x Support with feed

•

30 LBS

42 LBS

PLAN VIEW

PHOTOMETRICS

500

500

8’-0”

1

⁄4” O.A.

8’-2

12’-0”

1

⁄4” O.A.

12’-2

Actual performance may dier as a result of end-user environment and application.

1-LAMP T5HO

92% eciency
4599 delivered lumens

1000

70.8% up / 29.2% down

2-LAMP T5HO

91.7% eciency
9170 delivered lumens

69.2% up / 30.8% down

2000

1000

3-LAMP T5HO

92% eciency
13839 delivered lumens

68.2% up / 31.8% down

1000

2246 5th Street, Berkeley, CA 94710 • Tel: [phone] • Fax: [phone] • Email: [e-mail] • PeerlessLighting.com

Products in this document may be covered by one or more U.S. Patents and Patents Pending. Specifications subject to change without notice.
1-year limited warranty. Complete warranty terms located at www.acuitybrands.com/customerresources/terms_and_conditions.aspx

© 2012 Acuity Brands Lighting, Inc. All Rights Reserved. “Peerless” is a registered trademark of Acuity Brands Lighting.

SPM9  Staple Lens I/D

Indirect-Direct T5/T5HO

2