Peerless-AV DS-C560-2X2 User Manual
DS-C560-2X2
46"-60"
(117cm-152cm)
MAX
500 lb
(227 kg)
ENG
1
2014-04-14 #:009-9082-3.1 (2014-08-19)
This page intentionally left blank.
2
2014-04-14 #:009-9082-3.1 (2014-08-19)
WARNING
Do not begin to install product until you have read and understood the instructions and warnings contained in
this user guide. Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
This product must be installed onto at, hard, level surface to prevent tipping. The cart or stand is not afxed or
secured to the oor, and may therefore tip over and/or fall if screen and/or stand is shaken or hit. Displays must
be removed before moving cart. Not recommended for use in areas with heavy trafc. This product is intended
for indoor use only. Use of this product outdoors could lead to product failure or personal injury. Screws must
be tightly secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the
Maximum Load Capacity. Be careful not to pinch ngers when operating the mount. For support please call
customer care at 1-800-865-2112.
ENG
Symbols
To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
1
ENG
WARNING
Screws must get at
ENG
least three full turns
and t snug.
x3
2
ENG
Heavy
Display center.
ENG
Do not overtighten screws.
ENG
Tools Needed for Assembly.
3
+1/2
4
(13mm)
3
2014-04-14 #:009-9082-3.1 (2014-08-19)
Parts (Before beginning, make sure you have all parts shown below).
Parts List
Description Qty
A caster, 5" swivel 4 600-0026
B caster support 4 145-T1799
C cover 6 145-T1809
D base leg 2 145-T1767
E horizontal leg support 1 145-T1785
F base support tube 2 145-T1812
G base support 6 560-T1261
H vertical leg support 2 145-T1777
I adaptor bracket 8 145-T1792
J vertical support bracket 4 145-T1806
K computer cover 1 145-T1930
L computer shelf 1 145-T1931
M dual rail assembly 2 145-T1924
N locking tab 4 145-T1936
O cord bracket 4 145-T1929
P M8 x 16mm socket button screw 96 520-9527
Q M8 square nut 56 530-1066
R cover clip 24 590-0317
S M5 x 10mm type-f, socket pin screw 10 520-1164
T M5 x 12mm socket pin screw 4 520-1064
U 1/4" power bit 1 560-0263
V 5mm allen wrench 1 560-9640
W nylon shoulder washer 16 590-2233
X M6 x 12mm socket pin screw 16 520-1050
Y 4mm allen wrench 1 560-9646
A
(4)
caster
(4)
B
caster support
C
(6)
cover
(2)
F
base support
tube
(6)
G
base support
Part #
adaptor bracket
I
(8)
(2)
H
vertical leg
support
(2)
D
base leg
(1)
E
horizontal leg
support
4
(4)
J
vertical support
bracket
2014-04-14 #:009-9082-3.1 (2014-08-19)
(96)
P
M8 x 16mm
(2)
M
dual rail
assembly
(56)
Q
M8 square nut
(24)
R
cover clip
(1)
K
computer cover
S
M5 x 10mm
locking tab
(10)
L
computer shelf
(4)
N
(1)
T
M5 x 12mm
O
cord
bracket
(4)
(4)
(1)
U
1/4" power
bit
(1)
Y
4mm allen
wrench
(1)
V
5mm allen
wrench
(16)
W
nylon shoulder
washer
5
2014-04-14 #:009-9082-3.1 (2014-08-19)
(16)
X
M6 x 12mm
1
Repeat for each caster assembly.
B
Y
(5mm)
P (4)
A
Do not fully tighten hardware
P (2)
Q (2)
SIDE VIEW
6
2014-04-14 #:009-9082-3.1 (2014-08-19)
Loading...