Peerless-AV DCT600 Installation
Installation and Assembly - Heavy Duty I-Beam Clamp with Decoupler
This product is intended for use with UL
R
Before you start make sure
all parts shown below are
included with your product.
Listed products and must be installed by a
qualified professional installer.
C
IMPORTANT! Read entire
instruction sheet before you
start installation and assembly.
Maximum load rating 600 lb (272.2 kg): Combined
weight to all attached hardware and components is
not to exceed 600 lb (272.2 kg)
PART # QTY. DESCRIPTION
A 128-0422 1 I-beam tray
B 128-1206 2 3" I-beam clamps
C 520-1019 4 carriage bolt 1/2-13 X 1
D 520-1018 4 bolt 1/2-13 X 2
E 530-1008 4 lock nut 1/2-13
F 540-2005 4 flat washer 1/2-13
Parts List
Note: Some parts may appear slightly different than illustrated.
B
D
I-beam clamp has adjustments ranging
form 7" to 12" wide for I-beams
Model:
DCT800
A
F
E
B
WARNING
• If multi-display system, in combination with components exceeds 600 lb (272.2 kg) it therefore exceeds
the maximum load. Heavy Duty I-Beam Clamp with
Decoupler will not safely support a combined load
which exceeds 600 lb (272.2 kg)!
Note: For each step see corresponding illustration.
Attach brackets (B) to tray (A) using four 1/2-13 x 1"
carriage bolts (C), washers (F), and lock nuts (E).
Do not fully tighten.
Start four 1/2-13 x 2 bolts (D) into clamps (B).
Adjust clamps (B) securely around I-Beam. Tighten
(C,F,E) securely. Tighten four bolts (D) securely.
Attach the extension column according to the
instructions provided with it. Use a level to make sure
the column is plumb and make adjustments as
necessary.
1 of 1
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
ISSUED: 05-10-02 SHEET #: 128-9135-3 04-21-05
I-Beam
D
B
Loading...