Installation and Assembly - Heavy Duty I-Beam Clamp with Decoupler
This product is intended for use with UL
R
Before you start make sure
all parts shown below are
included with your product.
Listed products and must be installed by a
qualified professional installer.
C
Note: Read entire instruction sheet before you start
installation and assembly.
Maximum load rating 600 lb (272.2 kg) Combined
weight to all attached hardware and components is
not to exceed 600 lb (272.2 kg).
PART # QTY. DESCRIPTION
A 128-0423 1 I-beam tray
B 128-1205 2 2" I-beam clamps (DCT600)
D
C 520-1019 4 carriage bolt 1/2-13 X 1
D 520-1018 4 bolt 1/2-13 X 2
E 530-1008 4 lock nut 1/2-13
Parts List
F 540-2005 4 flat washer 1/2-13
Note: Some parts may appear slightly different than illustrated.
B
I-beam clamps have adjustment
ranges for both 15" and 16" I-beams
Model:
DCT600
DCT700
128-1206 2 3" I-beam clamps (DCT700)
A
F
E
WARNING
• If multi-display system, in combination with components exceeds 600 lb (272.2 kg) it therefore exceeds
the maximum load. Heavy Duty I-Beam Clamp with
Decoupler will not safely support a combined load
which exceeds 600 lb (272 kg)!
Note: For each step see corresponding illustration.
Attach brackets (B) to tray (A) using four 1/2-13 x 1"
carriage bolts (C), washers (F), and lock nuts (E). Do
not fully tighten.
Start four 1/2-13 x 2 bolts (D) into clamps (B).
Adjust clamps (B) securely around I-Beam. Tighten
(C,F,E) securely. Tighten four bolts (D) securely.
Attach the extension column according to the
instructions provided with it. Use a level to make
sure the column is plumb and make adjustments as
necessary.
B
I-Beam
D
B
1 of 1 ISSUED: 01-27-00 SHEET #: 128-9023-3 04-21-05
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.