Peerless-AV DCT300 Installation

Installation and Assembly - Heavy Duty I-Beam Clamp with Decoupler
This product is intended for use with UL
R
For customer service call 1-800-729-0307 or 708-865-8870. Visit the Peerless Web Site at www.peerlessindustries.com.
Before you start make sure all parts shown below are included with your product.
Listed products and must be installed by a qualified professional installer.
Maximum load rating 600 lbs (272 kg) Combined weight to all attached hardware and
components is not to exceed 600 lbs (272 kg).
Note: Read entire instruction sheet before you start installation and assembly.
PART # QTY. DESCRIPTION
A 128-0422 1 tray B 128-1194 2 clamps for i-beam C 520-1018 4 1/2-13 X 2" square head bolt
D
B
Parts List
F 540-2005 4 flat washer 1/2-13
Note: Some parts may appear slightly different than illustrated.
5" (127 mm)
adjustment range
Model:
DCT500
C
A
F
E
WARNING
• If multi-display system, in combination with compo­nents exceeds 600 lbs (272 kg) it therefore exceeds the maximum load. Heavy Duty I-Beam Clamp with Decoupler will not safely support a combined load which exceeds 600 lbs (272 kg).
Note: For each step see corresponding illustration. Attach brackets (B) to tray (A) using four 1/2-13 X 2" square head bolt (C), washers (F), and lock nuts (E). Do not fully tighten. Start four 1/2-13 X 1" carriage bolts (D) into clamps (B).
Adjust clamps (B) securely around I-Beam. Tighten (C,F,E) securely. Tighten four bolts (D) securely. Attach the extension column according to the instructions provided with it. Use a level to make sure the column is plumb and make adjustments as necessary.
B
I-Beam
D
B
1 of 1
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
© 2004 Peerless Industries, Inc. All rights reserved. Peerless is a registered trademark of Peerless Industries, Inc. All other brand and product names are trademarks or registered trademarks of their respective owners.
ISSUED: 05-05-99 SHEET #: 128-9020-3 04-21-05
Loading...