Peerless-AV ACC931-S Installation
Installation and Assembly:
A
CC937
A
CC937-S
Description Qt
y
. Part # Part #
A
M10 adapter bracket 4 201-1562 201-4562
B
M6 x 12 mm phillips screw 12 520-1128 520-1128
C
M6 flanged nut 12 530-1048 530-1048
D
M10 x 15 mm phillips screw 4 520-1305 520-1305
E
multi-washer (included with ONE-TP) 4 580-1036 580-1036
Parts List
M10 Adapter Brackets
Model: ACC937, ACC937-S
IMPORTANT! Read instruction sheet before you start installation and assembly.
Before you start make sure all parts listed are included with your product.
Note: Some parts may appear slightly different than illustrated.
To prevent scratching the screen, set a cloth on
1
a at, level surface that will support the weight of
the screen. Place screen face side down. Refer
to screen manufacturer's instructions or customer
service, for removing any knobs, base, cover, or
screw(s) on the back of the screen to prepare
mounting. These need to be removed to allow
the adapter brackets to be attached.
Place and center M10 adapter brackets (A) over
mounting holes on back of screen to locate point
of attachment.
NOTE: One M10 adapter bracket (A) must be
used for each screen mounting hole. If screen
has more than four screen mounting holes, additional M10 adapter brackets are required.
PLACE FLANGE
OVER MOUNTING
HOLES
B
A
D
A
A
CENTER BRACKETS
VERTICALLY ON
BACK OF SCREEN
C
E
PLACE FLANGE
OVER MOUNTING
HOLES
X
Y
BRACKETS DO
NOT HAVE TO BE
FULLY EXTENDED
Note: "X" dimensions should be equal. "Y" dimensions should be equal.
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
1 of 2
Y
A
X
ISSUED: 05-16-08 SHEET #: 120-9047-3 09-19-08
Attach extension adapter brackets (A) using two M6 x 12 mm phillips screws (B) and two M6 ange nuts (C) for
2
each bracket as shown in g 2.1. If attaching extension adapter brackets (A) to ONE-TP adapter bracket fasten
two multi-washers (E) using two M6 x 12 mm phillips screws (B) and two M6 ange nuts (C) for each bracket as
shown in g 2.2.
NOTE: For tilt adapter brackets with a tension knob, be sure ange is pointing in the same direction as the
tension knob.
g 2.1 g 2.2
SMART MOUNT ADAPTER BRACKETS ONE-TP ADAPTER BRACKETS
A
A
C
C
B
B
TENSION
KNOB
C
FLANGE
B
Secure adapter brackets to screen using four M10 x 15 mm screws (D) as shown below.
3
C
FLANGE
B
B
B
A
C
TENSION
KNOB
E
C
FLANGE
WARNING
• Do not overtighten. Overtightening may cause permanent damage to the screen.
D
SMART MOUNT ADAPTER BRACKETS ONE-TP ADAPTER BRACKETS
2 of 2
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
All other brand and product names are trademarks or registered trademarks of their respective owners.
ISSUED: 05-16-08 SHEET #: 120-9047-3 09-19-08
© 2008, Peerless Industries, Inc. All rights reserved.
D
Loading...