Peerless ACC 215, ACC 415, ACC 615 User Manual
Assembly Instructions - Metal Stud Fastener Kits
Parts List
Description Qty. Part No.
A toggler (ACC 215 only) 2 560-9708
toggler (ACC 415 only) 4 560-9708
toggler (ACC 615 only) 6 560-9708
B 1/4-20 x 2.5" phillips (ACC 215 only) 2 520-9521
1/4-20 x 2.5" phillips (ACC 415 only) 4 520-9521
1/4-20 x 2.5" phillips (ACC 615 only) 6 520-9521
C 1/4" SAE washer (ACC 615 only) 6 540-9440
Models: ACC 215, ACC 415, ACC 615
A
B
C
1 of 2
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
ISSUED: 05-23-02 SHEET #: 120-9012-4 10-29-07
FOR METAL STUD WALLS ONLY: Drill four 1/2"
(13mm) dia. holes through drywall and studs at
locations corresponding to wall plate. Insert togglers
(A) as shown below...
WARNING
• Product must be mounted through drywall that has a
minimum thickness of 1/2" and into metal studs, 26
gauge or heavier.
• Make sure that togglers are anchored into the center
of the studs as shown in figure 1. The use of an "edge
to edge" stud finder is highly recommended.
Pivot end of toggler (A).
A
A
∅ 1/2"
(13 mm)
Push into hole.
Rotate toggler (A)
clockwise to wedge it
against inside walls
of metal stud.
Slide plastic cap
forward while pulling
back firmly on ring.
Break off excess.
Align wall plate with
hole in wall and
fasten using
1/4-20 x 2.5" screw
(B) and 1/4"
washer (C).
B
fig. 1
wall plate
C
2 of 2
Visit the Peerless Web Site at www.peerlessindustries.com For customer service call 1-800-729-0307 or 708-865-8870.
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
ISSUED: 05-23-02 SHEET #: 120-9012-4 10-29-07
Loading...