PVM’”
38i
Unidirectional
Dynamic
MIcrophone
SPECIFICATIONS
Element Type:
Dynamic
(with
Hum
Compensation Coil)
Polar Pattern:
Cardlold
Impedance:
Low (300 ohms
Frequency Response:
50 to 16,000
Sensitivity:
Output Power Level
-56 dB (0 dB
Open Circuit Voltage
-75.5 dB (0 dB = 1
Hum Induction:
Equivalent to 9.0 dB SPL
(Hum output of microphone In a
millloersted
from a 9.0 dB SPL acoustic source)
Case (Housing):
Black solid metal
Windscreen:
Brazed steel mesh with dual Integral foam
pop
filters
Connector:
3-pin
XLR
+200/o)
Hz
=
1
mW/iO
microbar*)
V/mtcrobar*)
1
hum field is equal to its output
Weight:
7 oz. (198.5 grams)
Furnished Accessories:
Swivel adaptor, foam windscreen, and soft
carrying pouch
*lO microbars =
1
Pascal =
10 dynes/cm*
FEATURES
l
Clean, well balanced sound
l Very low handling and stand
l
Uniform
off-axis rejection
l
Hum-bucking
electrical
coil to reject induced
noise
noise
l Dual stage pop filtering
* Robust construction
l
External windscreen, stand adaptor
and soft carrying pouch supplied
DESCRIPTION
The
PVM’”
381 IS a unidirectional
dynamrc mlcrophone
performance optimized for hand-held
vocal excellence.
The frequency response IS carefully
tailored to provide a proper balance
with features and
between low frequencies and the mid-
high
presence rise clean, natural sound that can become
as sultry or forceful as the performer
desires.
resulting
in a
The
PVM’”
38i also features a refined
shock
suspensron
which provides a
very low sensitivity to annoying handling
and stand noises.
Feedback and coloration from nearby
monitors or the house system are effectively controlled by the very uniform
car-
dioid directional properties.
And the PVM 38i is rugged! With a
tough metal handle and brazed steel
wire outer grille, this microphone comes
ready for the road.
DIMENSIONS
INCHES
(MILLIMETERS)
The compact, handsome PVM 38i offers all that is needed for top vocal performance in any venue.
ARCHITECTURAL
&
ENGINEERING
SPECIFICATIONS
The microphone shall be a moving
dynamic type with a frequency
response of 50 Hz to 16,000 Hz. The
microphone shall have a cardioid polar
characteristic with a rear response that
is about 20 dB down. The
mrcrophone
shall have an output power level of
-56.0
dBM
per IO
microbar
pedance
where 0 dB = 1
and nominal im-
rating
of 300 ohms.
millrwatt
co11
The microphone shall have a
non-
reflecting black finish on a solid metal
case and a brazed metal screen. The
connector shall be a
3-pin
XLR
equivalent audio type and a swivel
adaptor shall be provided to mount on
a stand having
5/8”
27 thread. The
microphone shall have overall dimensions of
diameter. The
Peavey model
5%”
in length and
mlcrophone
PVM’”
17/8”
in
shall be a
38i or equivalent.
59
146 05)
I
2
jO.80
-_----------
r
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I’
POSlTlVE (INWARD) PRESSURE ON DIAPHRAGM
PRODUCES POSITIVE VOLTAGE AT
--------
WIRING DIAGRAM
‘-““““-““‘---‘---“-I
HUM COMPENSATION COIL
BLUE
_-_--------------------
PINIY2
RED
I
I
I
I
I
5 dB per division
180”
180”
Frequency Response
50 Hz 100 HZ 200 Hz 500 Hz 1 kHz PkHz
0” & 180”
Frequency Response
5
kHz 10 kHz
20 kHz
Proximity Effect
50 Hz 100 Hz 200 Hz 500 Hz
1 kHz 2kHz 5 kHz 10 kHz
20 kHz
PEAVEY ELECTRONICS CORPORATION
(“Peavey”) warrants this microphone to the
original retail purchaser to be free from defects
in material and workmanship for a period of
one (1) year from date of purchase; provided,
however, that the existence of this limited
warranty is subject to the conditions,
exclusions and limitations hereinafter set forth.
In case of a covered defect in material or
workmanship, Peavey will repair or replace the
microphone, at Peavey’s option, provided that
consumer:
(a) brings the defective microphone to any
Peavey Authorized Dealer or Service Center
and presents therewith a copy of the sales
receipt or other proof of purchase. If the
DEALER or SERVICE CENTER is unable to
provide the necessary warranty service, the
consumer will be directed to the nearest other
PEAVEY AUTHORIZED DEALER or SERVICE
CENTER which can provide such service; or
(b) returns the defective microphone,
shipping charges prepaid, to Peavey
Electronics Corporation, 711 A Street,
Meridian, Mississippi, and includes therewith a
written description of the problem, a copy of
the sales receipt or other proof of purchase
and consumer’s complete return address.
If the defect is remedial under this limited
warranty and the other terms and conditions
expressed herein have been complied with,
Peavey will provide the necessary warranty
service to repair or replace the mrcrophone
and will return it, freight collect, to the
consumer.
Under no circumstances will Peavey be
liable for any lost profits, lost savings or other
consequential or incidental damages arising
out of the use or inability to use the product,
even if Peavey had been advised of the
possibility of such damages.
THIS LIMITED WARRANTY IS IN LIEU OF
ANY AND ALL WARRANTIES, EXPRESSED
OR IMPLIED, INCLUDING, BUT NOT
LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR
PARTICULAR USE; provided, however, that
upon compliance with the other terms and
conditions necessary to the existence of the
express limited warranty, such implied
warranties are not disclaimed during the
applicable one year period from date of
purchase of this product.
SOME STATES DO NOT ALLOW
LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS OR THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE
ABOVE LIMITATIONS OR EXCLUSIONS MAY
NOT APPLY TO YOU. THIS LIMITED
WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS, AND YOU MAY ALSO HAVE OTHER
RIGHTS WHICH MAY VARY FROM STATE TO
STATE.
In the event any modification or disclaimer
of express or implied warranties or any
limitation of remedies contained herein
conflicts with applicable law, then such
modification, disclaimer or limitation as the
case may be, shall be deemed to be modified
to the extent necessary to comply with such
law.
Peavey Electronics Corporation gives this
limited warranty only with respect to Peavey
microphones purchased in the United States of
America. This limited warranty shall be void
and of no effect if:
(a) first purchase of the product is for the
purpose of resale; or
(b) the original retail purchase is not made
from an AUTHORIZED PEAVEY DEALER; or
(c) the product has been damaged by
accident or unreasonable use, neglect,
improper service or maintenance, or other
causes not arising out of defects in material or
workmanship.
Features and specifications subject to change without notice.
Peavey Electronics Corporation 711 A Street / Meridian, MS 39302-2898 / U.S.A. / (601)483-5365 /Telex 504115 / Fax 486-l 278
01993
#80301792
Printed in U.S.A.
11/93
Loading...