Peavey Automix 4 User Manual
The PD™4 allows connection of four stereo headphones to a power amplifier using resistor isolation on each
output to prevent overloading the amplifier. If more outputs are required, any number of PD 4’s can be linked
to meet your needs. The PD 4 also has a stereo/mono switch to allow a mono signal (connected tip-sleeve on
the input) to be routed to both the left and right headphone ear cups. The PD 4 can also be used with mono
headphones by setting the PD 4 for stereo and connecting a mono source to the tip and sleeve on the input.
CCaauu ttiioonn::
Care must always be taken when using headphones to prevent hearing damage.
SSPPEECCIIFFIICCAATTIIOONNSS::
IInnppuutt::
Stereo (tip-ring-sleeve) 1/4" phone jack will accept stereo or mono plug
OOuuttppuutt::
Four (tip-ring-sleeve) 1/4" phone jacks can also be used with mono headphones
SStteerreeoo//MMoonnoo SSwwiittcchh::
Stereo mode route stereo signal from input to outputs, mono position routes signal on tip of input to tip
and ring of output jacks
OOuuttppuutt IImmppeeddaannccee::
22 Ohm, suitable for low or high impedance headphones
DDiimmeennssiioonnss ((HH xx WW xx DD))::
4.4" x 3" x 1.5"
(11.18 cm x 7.62 cm x 3.81 cm)
WWeeiigghhtt
:
0.5 lbs. (23 kg)
SSPPEECCIIFFIICCAATTIIOONNSS PPDD
™™
44
HHeeaaddpphhoonnee DDiissttrriibbuuttiioonn SSyysstteemm
Features and specifications subject to change without notice.
Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com
©2003 Printed in the U.S.A. 11/03
80303113
SSPPEECCIIFFIICCAATTIIOONNSS PPDD
™™
44
HHeeaaddpphhoonnee DDiissttrriibbuuttiioonn SSyysstteemm
NNoottee::
Headphone impedance must be 16 Ohms or greater when using 5 or more
headphones in a multiple PD 4 application
PD™- 4 APPLICATIONS GUIDE
Power Amplifier
Mono/Stereo
from Amplier
Power Amplifier
-or-
Mono/Stereo
from Amplier
Loading...