Peavey 210TVX Specifications
P E A V E Y E L E C T R O N I C S
S P E C S
TM
210TVX
Bass Enclosure
SPECIFICATIONS
Frequency Response, 1 meter on-axis,
swept-sine in anechoic environment:
30 Hz to 15 kHz
Power Handling:
175 W continuous (26.5 V RMS)
350 W program
Sound Pressure Level, 1 watt, 1 meter in
anechoic environment:
95 dB (2.0V)
Transducer Complement:
2 x 10" Sheffield® bass guitar
speakers
1 x 1" Phenolic dome horn
tweeter
Box Tuning Frequency:
50 Hz
Crossover Frequency (Internal Passive):
3,000 Hz
Impedance:
Nominal:
4Ω
Minimum:
3.8Ω
Input Connections:
1 x 1/4" phone jack
Enclosure Materials and Finish:
3/4" MDF, Tolex® covered with
metal corners and an expanded
metal grille
Dimensions (H x W x D):
17" x 24.50" x 19.25"
(43.2 cm x 62.2 cm x 48.9 cm)
Net Weight:
66 lbs. (30.0 kg)
Features:
• Improved crossover for better
midrange tone
• Vents located on front of
cabinet
• Horn tweeter with level
control
• Protection circuit for horn
tweeter
Description
The 210TVX™ is designed as a full-range
bass guitar enclosure in a small package.
It may also be used as the top cabinet in
a bi-amped bass system. This enclosure
is covered with tough, black vinyl to give
the player a rugged and easy-to-clean
surface. The metal corners and grille add
protection from the bumps and bruises
encountered “on the road.”
The 210TVX utilizes two 10-inch
Sheffield® bass speakers, a horn tweeter
and a custom crossover designed for
great articulation, tone and clarity. A high
frequency level control is part of the
crossover so the high frequency output
can be tailored to complement any style
of playing. A protection circuit has been
incorporated into the crossover to help
prevent damage to the horn tweeter in
the event of overpowering. If the average
signal level going to the tweeter exceeds
a certain threshold, the protection circuit is
engaged. When this occurs, the horn will
almost completely stop producing sound,
until the signal level is reduced and the
circuit disengages. Then the horn tweeter
will again produce sound. Please note
that this protection circuit is for long-term
(average signal level) protection. It is still
possible for transients (short-term peaks)
to damage the horn.
Like our earlier TXF
enclosure has low frequency vents on the
front of the cabinet. This results in better
low frequency impact from the enclosure.
The 210TVX is a 4-ohm
enclosure capable of handling an input
power of up to 350 watts. This enclosure
can be used alone or with any other bass
guitar enclosure from Peavey. Be sure to
check the amplifier specifications to verify
the minimum impedance rating of the amp
used to power this enclosure.
Tolex® is a registered trademark of DiversiTech
General, Inc.
™
series, this
3 + 2 YEAR LIMITED WARRANTY
Logo referenced in Directive 2002/96/EC Annex IV
(OJ(L)37/38,13.02.03 and defined in EN 50419: 2005
The bar is the symbol for marking of new waste and
is applied only to equipment manufactured after
13 August 2005
NOTE: For details, refer to the warranty statement
Copies of this statement may be obtained by contacting
Peavey Electronics Corporation
P.O. Box 2898, Meridian, Mississippi 39301-2898
Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305
©2006
Features and specifications subject to change without notice.
(601) 483-5365 • FAX (601) 486-1278 • www.peavey.com
EX000056
Loading...