Peavey 15040 SP-15825 RB User Manual

PEAVEY ELECTRONICS

15” Scorpion®
Replacement
Basket

The Peavey Scorpion® Plus™ 15”
loudspeaker was designed to high
level professional requirements,
which is sound reinforcement,
public address, and low frequency
musical instrument applications.
Impregnated with Kevlar® to
maintain an extremely rigid
platform that can provide enhanced
linearity at high drive levels. At any
drive level, Kevlar gives the added

benet of greater mechanical
damping, resulting in higher delity

through lower distortion.

The Scorpion Plus unique
suspension design further
contributes to the high reliability in
very low distortion by allowing very
long excursions with associated
low distortion. The large spoke
die cast, aluminum frame, and

eld replaceable cone assembly

are features usually found in ultra
premium transducers such as the
Peavey Black Widow® Series.

The Scorpion Plus 15” Kevlar®
impregnated cone loudspeaker is
another example of the versatility
and reliability sound in all Peavey
products.

Kevlar® is a registered trademark of DuPont Company

SPECIFICATIONS

Diameter – 15”
Nominal Impedance – 8 ohms / 4 ohms
Power Handling Capacity –
Continuous 200 watts
Program* 400 watts
Sensitivity – 101 dB (8 ohms) / 100 dB (4 ohms)
Voice Coil Diameter – 2.5 inches
Flux Density – 13000 Gauss
Depth – 5 7/8 inches
Net Weight – 12 ¾ lbs.

THIELE/SMALL PARAMETERS

Znom 8 Ohms 4 Ohms
Fs 50.2 Hz 49.4 Hz

RE 5.54Ω 3.35Ω

QTS 0.326 0.415
VAS 132.4L 138.9L
VD 22.1 in3 (362 ml) 22.1 in3 (362 ml)

Efciency (half space) 4.70% 3.62%

SD (diaphragm area) 0.0731M2 0.0731M2

*This specication requires a minimum of 2 dB of amplier headroom.

Scorpion®

Logo referenced in Directive 2002/96/EC Annex IV
(OJ(L)37/38,13.02.03 and defined in EN 50419: 2005

The bar is the symbol for marking of new waste and

is applied only to equipment manufactured after

13 August 2005

Basket
Assembly
Replacement

Replaceable baskets
eliminate the need for

1

2

re-coning speakers
and the frustration and
delays associated with
the re-coning process. It
only takes a few minutes
to replace a basket and
you are back in business.
It just can’t get any
easier than the four steps
outlined here.

3

Baskets are replaced in four easy steps:

1 Remove three screws on back of magnet structure.

2 Lift the magnet structure off the basket frame.

3 Clean the voice coil “gap”.

4 Align screw holes, lower structure into place on new

basket frame, insert screws and tighten.

4

NOTE: For details, refer to the warranty statement. Copies of this statement may be obtained online at www.peavey.com.

Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305

ONE YEAR LIMITED WARRANTY

Features and specications subject to change without notice.

[phone] • FAX [phone] • www.peavey.com

©2011 Printed in the U.S.A. 1/11 80300072