Peavey 03609920-RST-AG Installation Guide

Elements® Pole

Mounting System

Installation Manual

www.peavey.com

Elements® Pole Mounting System

Installation Manual

The Elements® Pole Mounting System is a simple and straightforward pole mounting solution
for the Peavey® Elements Series speaker. With its customizable angle adjustment, it can support
installations in a wide range of locations.

INSTALLER IS SOLELY RESPONSIBLE FOR THE FOLLOWING:

• Complying with all applicable building codes (local and/or national)

• Making sure that the Elements Pole Mounting System is appropriate for the specified install.

• Using only parts supplied by Peavey.

• Ensuring the safe installation of Pole Mounting System

CAUTION: Before attempting to suspend these speakers, consult a certified structural engineer. The
speaker can fall from improper suspension, resulting in serious injury and property damage.

CUSTOMER SUPPORT

Thorough reading of the Installation manual is necessary for a successful and safe installation.

Any additional assistance can be obtained by contacting our Customer Service team
toll-free at 877-732-8391or via email at [e-mail].

PARTS DEPARTMENT

To order replacement parts, please call us at [phone] (toll free in the US) or 601-483-5365.
The Parts Department extension is 1386. Our business hours are 8 a.m. - 5 p.m. Central Time,
Monday - Friday. Hold times may be long during peak hours. If you have to wait on hold, feel
free to leave a name and number and one of our Parts Sales Coordinators will contact you as
soon as possible. Payment can be made via credit card, or we can ship COD to a place of business
only.

TOOLS REQUIRED FOR ASSEMBLY

• Wrenches: 7/16, 9/16, ¾ socket driver, box-end or crescent wrench

• Flathead Screw driver

• Pliers used to pull cable tie tight against pole

• Sturdy platform or ladder – for safety, be sure to have a second person to help hold the speaker
during installation.

Elements® Pole Mounting System

Installation Manual

COMPONENT LIST

• Stainless steel cable straps Part number: 30903757 (x 4)

• Speaker Mount assembly

• Pole Mount assembly

• Speaker to Speaker Mount bolts with washers

Part Numbers:
Bolt: 31502137 (x 4)
Washer: 31502132 (x 4)

• Pole Mount assembly to Speaker Mount assembly bolts

Part numbers:
Bolt: 31502138 (x 3)
Nut: 31502134 (x 3)
Washer: 31502130 (x 6)
Spacers: 30908003 (x 2)

ASSEMBLY INSTRUCTIONS

1. Preset angle - Start by loosening the pivot bolt (1) and removing the angle set bolt (2). If you
know the desired angle for the speaker beforehand, adjust the angle and replace the angle set
bolt. Tighten the pivot bolt, while hand tightening the angle set bolt. Do not over tighten.

1

2. Remove bolts from the rear speaker panel.

2

3. Mount speaker mount to speaker

- Secure speaker mount assembly to
speaker. With the four screws from the
rear panel of the speaker removed,
attach assembly to speaker as shown.

* Note: start with top left screw, then
top right. Tighten screws, and then
use your hand to align the holes at the
bottom of the bracket. Place screws
into bottom of the bracket. Tighten all
screws.

4. Make sure the pivot bolt and angle set
bolt are secure, but not overtightened.
Keeping the bolts loose at this point will
allow for easier adjustment of the angle
once the speaker is attached to the
pole.