PDR Mounts iwbB250 User Manual

Mounts by

A division of David Engineering & Mfg. Inc.

M odel

IWB-250 IN WALL BOX INSTRUCTIONS

Thank you for purchasing this PDR product
To ensure the correct usage, please read and follow the instruction

All PDR mounts and adapters carry a lifetime warranty against defects in material and workmanship.

We are not liable for improper installation that results in damage

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the display
and the IN WALL BOX (IWB-250)

manual thoroughly. Please store the instructions in a safe place

to mounts, adapters or presentation equipment.

Special techniques are necessary for installation of the panel display mount.

Extreme caution should be used cutting into walls. Electrical wiring and plumbing may exist and could cause DAMAGE OR SHOCK

Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.

This product (IWB-250) is intended for use in standard 2”x 4” (wood) construction with studs on 16” centers.

All electrical connections should be performed by a qualified electrician.

for future reference.

Shown with AWM-250 (not included)
Can also be used with the AWM-175 (not included)

IWB-250
In wall box

1

WARNINGS AND PRECAUTIONS

The wall structure must be capable of supporting at least 4 times the weight of the display and the IWB-250 kit. Check with a qualified
installer to verify the walls integrity to support the display and the in wall kit per instructions. Failure to do so could cause serious injury.

Caution: Special consideration should be taken when mounting to a load bearing wall.
Consult with your local building code or a licensed Contractor.
Damage to the structure could occur.

Note: Incorrect installation can cause the

INSTALLATION ON 2 X 4 WOOD STUD WALLS ONLY

Always install so that the load is carried by the wall support structure (not the dry wall ) . The wall structure must be able to support at least 4 times the weight of the display
and the IWB-250 kit.

Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any

water is possible. These can result in fire or electric shock.

Do not install close to an air conditioner intake or outlet. Do
oily smoke or tobacco smoke. Fire could result.
Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the ventilation..
The internal temperature could elevate and possibly result in fire. Install the in wall box IWB- (4") or more away from surroundings. 250

Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the panel display
falling.

MAXIMUM WEIGHT - 250 Lbs. ( 113 Kg.)

WARNING

display to fall and cause injury.

Total load of the

Display + IWB-250

CAUTION

not install in locations where there are excessive amounts of dust,

Use the specified bolts and screws in the specified places and tighten firmly. Failure to do this could cause injury if the display falls.

Do not alter any of the parts. Do not use broken parts. This

Always use at least two people to perform the installation work. Injury could result from dropping heavy objects.

Caution: installation of the unit is to be carried out by qualified technicians only. Install in an appropriate location by
checking the wall structure and durability for safety and accident prevention

WARNING

could result with injury due to the display falling.

Rev 011008

2

Model IWB-250

In Wall Box

SPECIFICATIONS

30.25

32.01

Can be used with the following mounts:
AWM-175
AWM-250

16.98

3.54

15.43

3