PDR Mounts cpm100 User Manual

Mounts by

A division of David Engineering & Mfg. Inc.

M odel

CPM-100 CEILING PIPE MOUNT

Thank you for purchasing the PDR product
To ensure the correct usage, please read and follow the instructions

All PDR mounts and adapters carry a limited lifetime warranty from ship date against defects in material and workmanship.
Check the PDR website for details @ www.PDRmounts.com. We are not liable for improper installation that results in damage

to mounts, adapters or presentation equipment.

To ensure customer safety, be sure to decide the installation location so that the strength is sufficient to withstand the weight of both the panel
display and the mount.
Always use at least two persons for all installations.
Fully tighten all of the mounting screws as specified in the installation instructions.

manual thoroughly. Please store the instructions in a safe place

Special techniques are necessary for installation of the panel display mount.

Do not attempt to perform this work by yourself.
Request an installation specialist to install this unit.
Manufacturer assumes absolutely no responsibility for injuries and damages that may occur due to improper installation and handling.
Please remember that if you remove the ceiling mount from the ceiling later, you will find the screw holes left by any anchor bolts.

Features

! Used with standard 1 ½” Pipe (not supplied)

for future reference.

! Can be used on a flat or vaulted ceiling, rotates 90 degrees
! 100mm VESA hole pattern, or Can be used with any PDR mount
! Easy cable access
! 500 lb load rating

CPM100 ADJUSTS FROM

FLAT (0°) THROUGH

TO A FULL 90°

1

90°

45°

SAFETY SCREW

INSTALLATION LOCATION

The ceiling where the mount is to
the panel display and ceiling mount. Measures should
withstand the force of earthquakes,

Note: Incorrect installation can cause the p

INSTALLATION ON A WOODEN CEILING

Always install so that the load is supported by a wood stud. If
Do not install on decorative posts or plaster board.

Avoid installing in locations where the temperature and humidity are excessively high, and where contact with any

water is possible. These can result in fire or electric shock.

Do not install close to an air conditioner intake or outlet. Do
oily smoke or tobacco smoke. Fire could result.
Do not block the ventilation holes. Leave sufficient clearance in regard to the surroundings to avoid blocking the ventilation..
The internal temperature could elevate and possibly result in fire. Install the panel (4") or more away from surroundings.

Do not install in locations where there is excessive vibration or impact. Injury and damage could result from the panel display
falling.

Total load of the panel (p

be installed must be capable of long-term support of the total load of

MAXIMUM WEIGHT - 500 Lbs. ( 227 Kg.)

WARNING

vibration and other external forces.

anel display to fall and cause injury.

the strength of the wood studs is not sufficient, add reinforcement.

Always confirm the center of the stud is used for the installation.

CAUTION

also be taken to ensure sufficient strength to

anel display + wall mount)

not install in locations where there are excessive amounts of dust,

Use the specified bolts and screws in the specified places and tighten firmly. Failure to do this could cause injury if the pan
display falls.
Do not alter any of the parts. Do not use broken parts. This

Always use at least two people to perform the installation work. Injury could result from dropping heavy objects.

Caution: Installation of this unit must be carried out by a qualified technician.

Rev 033108

WARNING

could result with injury due to the panel display falling.

2

el