PCTEL Glass Mount GPS L1 Antenna, Maxrad Installation Instructions Manual

Glass Mount GPS L1 Antenna

Installation Instructions

Part #: MIS-AGPS-GM

Printed in the U.S.A.

WARRANTY

A. General Warranty. PCTEL, Inc (“PCTEL”) represents
and warrants that the Products furnished hereunder shall
be free from defects in material and workmanship for a
period of two (2) years from the date of shipment by
PCTEL under normal use and operation. PCTEL sole and
exclusive obligation under the foregoing warranty shall be
to repair or replace, at its option, any defective Product
that fails during the warranty period. The expense of
removal and reinstallation of any item is not included in
this warranty. THE FOREGOING WARRANTY IS
EXCLUSIVE AND IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR APARTICULAR PURPOSE AND
ANY WARRANTIES ARISING FROM A COURSE OF
DEALING, USAGE OR TRADE PRACTICE WITH
RESPECT TO THE PRODUCTS. Repair or replacement
in the manner provided herein shall be the sole and
exclusive remedy of Buyer for breach of warranty and
shall constitute fulfillment of all liabilities of PCTEL with
respect to the quality and performance of the Products.
PCTEL reserves the right to inspect all defective Products
(which must be returned by Buyer to PCTEL factory
freight prepaid). No Products will be accepted for
replacement or repair without obtaining a Return Materials
Authorization (RMA) number from PCTEL Customer
Service [by telephone: [phone] or email:
[e-mail]]. Products returned
without an RMA number will not be processed and will be
returned to Buyer freight collect. PCTEL shall have no
obligation to make repairs or replacement necessitated by
catastrophe, fault, negligence, misuse, abuse, or accident
by Buyer, Buyer’s customers or any other parties. The
warranty period of any repaired or replaced Product shall
not extend beyond its original term.

B. Warranty Conditions. The foregoing warranty shall
apply only if: (i) the Product has been properly installed
and used at all times in accordance, and in all material
respects, with the applicable Product documentation; (ii)
no modification, alteration or addition has been made to
the Product by persons other than PCTEL or PCTEL’s
authorized representatives or otherwise approved by
PCTEL; and (iii) the Product has not been subjected to
misuse, neglect or unusual physical, electrical or electro­magnetic stress, or some other type of accident. C.
Disclaimer. PCTEL DOES NOT WARRANT THAT THE
OPERATION OF THE PRODUCTS IS ERROR-FREE OR
THAT OPERATION WILL BE UNINTERRUPTED. IN NO
EVENT SHALL PCTEL BE RESPONSIBLE FOR
DAMAGES OR CLAIMS OF ANY NATURE OR
DESCRIPTION RELATING TO (i) SYSTEM
PERFORMANCE, INCLUDING COVERAGE, (ii)
BUYER’S SELECTION OF PRODUCTS FOR BUYER’S
APPLICATION AND/OR (iii) FAILURE OF PRODUCTS
TO MEET GOVERNMENT OR REGULATORY
REQUIREMENTS.

RETURNS

In the unlikely event a defect occurs in this product,
please work through the dealer or distributor from which
this product was purchased. PCTEL provides complete
service and support to all of its dealers and distributors.

© 2007 PCTEL, Inc. - Broadband Technology Group

471 Brighton Drive, Bloomingdale, Illinois 60108-3102

All Rights Reserved

INSTALLATION INSTRUCTIONS:

1. Determine the installation location of the antenna on the windshield or the rear window. Make sure that
the mounting glass surface is clean and free of debris and any imbedded obstructions such as antenna
wires, defroster wires, heavy tinting, etc.

Notes:

• The recommended location is behind the rearview mirror, above the mounting foot on the windshield.

• Do not mount the antenna to the dashboard or the rear deck as the antenna may obstruct the view of

the vehicle driver.

• For optimum performance, mount the antenna to the inside surface of the vehicle’s glass.

2. Test fit the antenna on the selected area prior to removing the release liner from the tape on the
antenna’s mounting surface.

3. Remove the release liner and carefully position the antenna above the selected mounting area.

4. Place the antenna on the mounting surface and apply even pressure to allow the foam tape to conform
to the windshield curvature. 50% of the bond strength is achieved after 20 minutes. Avoid contact with
the antenna for a minimum of 20 minutes after initial installation. Full bond strength of the adhesive tape
is realized after 72 hours.

C a u t i o n

The adhesive tape is very strong and will bond instantly on the mounting surface. Once the antenna is
placed on the surface, it cannot be moved.