PCI Private PCITP1 User Manual

Telematics Platform 1 (TP1)

Installation and User Manual

PCI Private Limited
35 Pioneer Road North
Singapore 628475

Copyright © 2019 PCI Private Limited. All rights reserved.

PCI Private Limited is a trademark of PCI Private Limited. All other trademarks are the property of their
respective owners.

PCI Private Limited endeavours to ensure that the information in this document is correct and fairly stated,
but PCI Private Limited is not liable for any errors or omissions. Published information may not be up to
date, and it is important to confirm current status with PCI Private Limited.

This technical data may be subject to U.S. and international export, re-export or transfer (export) laws.
Diversion contrary to U.S. and international law is strictly prohibited.

May 2019

1. Component Overview

2. FCC, IC and CE Compliance Statements

3. Installation Planning

4. Mounting Options

Pin #

Function

Pin #

Function

1 VBATT

7

CAN1_H

2 DIGITAL IN

8

CAN1_L

3 CAN2_H

9

CHASSIS GROUND

4 CAN2_L

10

DIGITAL OUT

5 CHASSIS GROUND

11

CHASSIS GROUND

6 IGNITION SENSE

12

GROUND

Pin #

Function

1 ENET_TX1_P

2 ENET_RX1_P

3 ENET_TX1_N

4 ENET_RX1_N

Component Overview

Telematics Platform 1 (TP1) Characteristics

Requirements Conditions

Operating Temperature -30° C to 70° C (-35° F to 158° F)

Operating Voltage 12 or 24 Volts DC

Operating Current 500mA max @ 12V

250mA max @ 24V

Sleep current 10mA max @ 12V

Connector Pinouts

12-pin Main Connector DT13-12PA

4-pin Ethernet connector 43-01229

The TP1 system has no user-serviceable parts. The TP1 contains a permanent lithium coin cell for

maintaining the real time clock; proper recycling or disposal per local law is required for all components

of the TP1.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in an industrial installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.

This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.