Date: 03-02-2016 www. pbteen.com Page 1 of 13
Rev:
COSTA LOFT BED
! WARNING:. Failure to follow these warnings and assembly
instructions could result in serious injury or death. To help prevent serious
or fatal injuries from entrapment or falls:
Read all instructions before assembling bunk bed.
Before each usage or assembly, inspect bunk bed for damaged hardware, loose joints,
missing parts or sharp edges. DO NOT use bunk bed if any parts are missing or broken.
DO NOT use substitute parts. Contact pottery barn teen for replacement parts and
instructional literature if needed.
Follow the information on the warnings appearing on the upper bunk end structure and
on the carton. DO NOT REMOVE WARNING LABEL FROM BED.
Always use the recommended size mattress or mattress support, or both, to help prevent
the likelihood of entrapment or falls.
Ensure thickness of mattress on upper bunk does not exceed 7 inches and the surface of
mattress must be at least 5 inches (127 mm) below the upper edge of guardrails.
Ensure both upper and lower bunk are assembled to the highest position when using the
product as a bunk bed.
Use only mattress which is 74"-75" long and 52.5"-53.5" wide on upper bunk.
Do not allow children under 6 years of age to use the upper bunk.
Periodically check and ensure that the guardrail, ladder, and other components are in their
proper position, free from damage, and that all connectors are tight.
Do not allow horseplay on or under the bed and prohibit jumping on the bed.
Prohibit more than one person on the upper bunk.
Always use the ladder for entering and leaving the upper bunk.
Use of a night light may provide added safety precaution for a child using the upper bunk.
Always use guardrails on both long sides of the upper bunk. If the bunk bed will be placed
next to the wall, the guardrail that runs the full length of the bed should be placed against
the wall to prevent entrapment between the bed and wall.
The use of water or sleep flotation mattresses is prohibited.
If refinishing, use a non-toxic finish specified for children's products.
STRANGULATION HAZARD - Never attach or hang items to any part of the bunk bed
that are not designed for use with the bed; for example, but not limited to, hooks, belts
and jump ropes.
This loft bed meets the requirements of ASTM F1427-13
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Date: 03-02-2016 www. pbteen.com Page 2 of 13
Rev:
Important Safety Instructions:
(A) Left post
(B) Right post
(C) Vertical panel 1
(D) Vertical panel 2
(E) Vertical panel 3
(F) Vertical panel 4
(G) Headboard upper panel
(H) Headboard lower panel
(I) Headboard shelf
(J) Vertical panel 5
(K) Vertical panel 6
(L) Vertical panel 7
(M) Vertical panel 8
(N) Footboard panel
(O) Footboard shelf
(P) Ladder
(Q) Upper side rail
(R) Lower side rail
(S) Center support rail
(T) Slat roll
2x
2x
1x
1x
1x
1x
1x
1x
3x
1x
1x
1x
1x
1x
3x
1x
2x
2x
1x
1x
C B A D E F G I J A B K L M N O P Q R
S T H
Please read all instructions carefully before assembling.
For your safety, assembly by two or more adults is strongly recommended.
Keep instructions for future use.
Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
Pre-assembly:
Remove all parts and hardware from the box and lay out on a clear carpeted or scratch-free work surface, as this
will avoid damaging parts during assembly. The shipping box provides an ideal work surface.
Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
Use the parts and hardware lists below to identify and separate each of the pieces included.
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
The use of power tools to aid in assembly is not recommended. Power tools can damage hardware and split
wood.
Parts Included:
Date: 03-02-2016 www. pbteen.com Page 3 of 13
Rev:
Hardware Included:
Fitting
Flat washer
Spring washer
Short Allen bolt
M6x30 mm
24x
98
98
62
Medium Allen bolt
Long Allen Bolt
Allen key
Wood Screw
M6x50 mm
M6x65 mm
4 x30 mm - 14x
24
12 1 32x
(A) Left post
(B) Right post
(C) Vertical panel 1
(D) Vertical panel 2
(E) Vertical panel 3
(F) Vertical panel 4
(G) Headboard upper panel
(H) Headboard lower panel
(I) Headboard shelf
1x
1x
1x
1x
1x
1x
1x
1x
3x
C B A D E
F G H I I
I
Tools Required (not included): Philips Head Screwdriver
Assembly Instruction Steps:
Look for the letter sticker A,B,C,D … on the parts to separate for assembly
I. ASSEMBLY THE HEADBOARD
Date: 03-02-2016 www. pbteen.com Page 4 of 13
Rev:
Loading...