PBA Safety Speakman SE 607 Installation Maintenance And Operating Instructions

SE - 607

Installation, Maintenance and Operating Instructions

DESCRIPTION

Floor mounted EMERGENCY DELUGE SHOWER and AERATED EYE/FACE WASH combination
unit. Shower is supplied with a 25mm stay open full flow ball valve, activated by a triangle pull rod.
Eye/Face wash is supplied with a 15mm stay open full flow ball valve,activated by a activation
paddle handle or foot pedal.

SPECIFICATIONS

SHOWER EYE WASH

SHOWER HEAD
VALVE
ACTIVATOR

- 200mm ABS Cycolac

- 25mm Stainless Steel

- 304 Stainless Steel Tube

EYE/FACE WASH
VALVE
ACTIVATOR
STANCHION
BASE PLATE
FOOT PEDAL ASSEM

- Aerated, ABS Cycolac S/S Inserts

- 12mm Stainless Steel

- 304 Stainless Steel Paddle Handle

- 304 Stainless Steel Tube

- 304 Stainless Steel

- 304 Stainless Steel Tube

INSTALLATION

After unpacking carton, ensure all components are present. Mark out the floor and mount the bottom
stanchion section using suitable anchors (10-12mm x 50 Dynabolt). Then assemble top section (use
pipe sealant on all joints). Assemble pull rod and shower head, attach paddle handle and foot pedal.
Once the unit is completely assembled connect water supply to 32mm top inlet nipple. Failure to use
potable water can result in emergency units producing impure or contaminated water causing
possible further injury.Test unit.

NOTE : This unit should be connected to an uninterrupted source of potable water, no less than
25mm (1"), with a minimum flowing pressure of 130KPa and a maximum static pressure of 860 KPa.

OPERATION

The shower is activated by pulling the triangle pull rod. Once the valve is activated the head will
continue to discharge water until the valve is manually closed, this is done by pushing the pull rod to
the off position.

ON

OFF

SPEAKMAN

SAFETY PRODUCTS

R

The eye wash is activated by pushing the paddle
handle rearward. The unit will operate until the
paddle handle is manually pulled to the off position.

ON PositionOFF Position

150mm

Ø 12mm
4 places

Base Plate

150mm

Details

25mm

25mm

FLOW DATA

EYE-WASH

FLOW PRESSURE (KPa) : 136
FLOW RATE (LPM) : 36

SHOWER

FLOW PRESSURE (KPa) : 34 69 103 138 172
FLOW RATE (LPM) : 76 76 76 76 76

1090

2134

1753

1650

FREE CALL 1 800 444 022

www.pbasafety.com.au

SE 607

Combination Deluge Shower & Eye/Face Wash

ISO 9002

Lic QEC13179

SE 607 SPARE PARTS LISTING

1

12

Aerator Screen Assembly
Part No - G05 0384

8

2

Aerator Screen Assembly & Cap
Part No - 05 1177 PC

3

4

Shroud Maintenance Kit

Part No - G10 0041

Complete Shroud Assembly

Part No - G10 0042

6

PULL-ON

S

P

E

13

AKMAN EME

RGENCY

S

HOWE

R

S

7

11

Supply Line Strainer Assembly

Part No - G21 0082 PCP

14

15

WARNING : Use only genuine Speakman parts when replacing or repairing

components. When ordering quote correct part numbers listed below.

To order free call 1 800 444 022 or free fax [phone]

No. DESCRIPTION PART No.

1

Aerator Sreen Assembly

2

Aerator Screen Assembly & Cap

3

Shroud Assembly Repair Kit (1 side)

4

Shroud Body & Aerator Assy. (1 side )

5

12mm Activation Ball Valve & Push Handle

6

200mm Cycolac Shower Head

7

Combination Frame

8

25mm Acitvation Ball Valve & Handle

9

Foot Pedal Connect Rod

10

Foot Pedal Activator Assembly

11

Inline Filter Assembly

12

Shower Arm 25mm BSP
Pull Rod Assembly

13

Stainless Steel Bowl

14
15

Strainer Gauze

ill.1029 (SE 607 S/P)

G05 0384
05 1177 PC

G10 0041
G10 0042

SE 910V

SE 870

SE FRAME

SE 911

SA 03003

SE TREADLE

G21 0082
SC 02001
SA 02008

68 0033

G21 0080

SPEAKMAN

R

SAFETY PRODUCTS

4

5

11

9

SE 607

10

Combination Deluge Shower & Eye/Face Wash

ISO 9002

Lic QEC13179

FREE CALL 1 800 444 022

www.pbasafety.com.au